Canon EOS Rebel G Flash Replacement

Canon EOS Rebel G Flash Replacement

Canon EOS Rebel G Flash Replacement Accessing components of the flash mechanism and bulb.

Written By: Zach

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 1 of 7

Canon EOS Rebel G Flash Replacement

INTRODUCTION This guide will instruct you how to install the flash on your camera.

TOOLS: Precision Utility Knife (1) Phillips #00 Screwdriver (1) Soldering Workstation (1) Spudger (1)

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 2 of 7

Canon EOS Rebel G Flash Replacement

Step 1 — Front Panel 

Using a #00 Phillips screw driver, remove three 4.4 mm Phillips screws as indicated by the red circles.

Step 2



Using your finger, peel back the textured grip so the components are separated.

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 3 of 7

Canon EOS Rebel G Flash Replacement

Step 3



Using the flat end of a spudger, loosen the connection between the front panel and the device.



Remove the front panel using your hands.

Step 4 — Flash



Pop the flash up with your thumb

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 4 of 7

Canon EOS Rebel G Flash Replacement

Step 5 

Unscrew the two screws on the front of the flash near the bulb cover.

Step 6



Close the flash.



Lift the flash cover off.

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 5 of 7

Canon EOS Rebel G Flash Replacement

Step 7



Pull off yellow capacitor from flash wiring.

Step 8 

© iFixit — CC BY-NC-SA

www.iFixit.com

Remove white cocking with a razor blade, and then unsolder connection.

Page 6 of 7

Canon EOS Rebel G Flash Replacement

Step 9



Remove the flash cover to access the flash bulb.



After wires are unsoldered, slide flash bulb out from housing.

To reassemble your device, follow these instructions in reverse order. This document was last generated on 2017-06-23 10:53:36 AM.

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 7 of 7