Disassembling Cambridge Audio A3i Case

Disassembling Cambridge Audio A3i Case

Disassembling Cambridge Audio A3i Case Written By: Colby

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 1 of 5

Disassembling Cambridge Audio A3i Case

INTRODUCTION This guide describes the steps to opening the case.

TOOLS: 8" Needle Nose Plier (1) Phillips #2 Screwdriver (1)

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 2 of 5

Disassembling Cambridge Audio A3i Case

Step 1 — Case 

Remove 2 screws from each side of the amplifier.



Remove 2 screws on rear of device. Slide top cover up and back from main case.

Step 2

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 3 of 5

Disassembling Cambridge Audio A3i Case

Step 3



Remove 3 screws on bottom of case.



Remove 13 screws on rear panel.

 Do not move the rear panel too far, as the power cord is still connected. Step 4

© iFixit — CC BY-NC-SA

www.iFixit.com



Using a pair of pliers, squeeze the retainer for the power cord as shown and pull it toward the external side the panel.



It may require some wiggling, but it should slip out of the hole and then off of the cord.

Page 4 of 5

Disassembling Cambridge Audio A3i Case

To reassemble your device, follow these instructions in reverse order. This document was last generated on 2017-06-17 09:59:44 PM.

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 5 of 5