(1) Back Assembly (1) Right & Left Side Assemblies (1) Seat Assembly
Tools Required: Phillip's Head Screwdriver 4MM Allen Wrench (Included)
Assembly Instructions Step One: Set Up READ ENTIRE INSTRUCTIONS BEFORE BEGINNING! Carefully remove contents from box. Make sure that all parts and hardware are included.
Step Two: Back Assembly Place Back Assembly Nametag Side down on a flat clean surface. Align pre-drilled holes of the Right & Left Side Assemblies with Back Assembly (Left Picture). Attach using (2) 3” Hex 1/4” Lags (Right Picture). Repeat process on other side.
Step Three: Seat Assembly Flip Chair to standing position. Place Seat Assembly on top of Seat Supports and push toward the Back Assembly. Before attaching make sure that the Seat Assembly is in place properly, and that the feet rest squarely on the ground. Then attach using (2) 3” Hex 1/4” Lags (Right Picture). Repeat process on other side.
WARRANTY QUESTIONS OR COMMENTS PLEASE CALL TOLL FREE AT 1-800-809-3114 1
Step Four: Seat Support Attachment Place Chair on its back. Attach Seat Support to Seat Assembly using (2) 1-1/4” Phillip’s Head Screws (Left Picture). Repeat Process on other side.
Step Five: Back & Seat Attachment Attach Back Assembly to Seat Assembly using (3) 3” Hex 1/4” Lags through pre-dilled holes in the Lower Back Support (Right Picture).
Step Six: Tightening of Hardware Tighten all connections. Do not over tighten!!! Over tightening of hardware can cause damage to the item.