Hardware: (28) 3” Hex 1/4” Lags (10) 3/4” Pan Head Screws (2) Thumb Screws
(1) Table Top (2) Leg Assemblies (2) Upper Leg Stretchers (2) Lower Leg Stretchers (2) Long Aprons
Tools Required: Phillip's Head Screwdriver 4MM Allen Wrench (Included)
(2) Short Aprons (1) Mid Umbrella Stretcher
Assembly Instructions Step One: Set Up READ ENTIRE INSTRUCTIONS BEFORE BEGINNING! Carefully remove contents from box. Make sure that all parts and hardware are included.
Step Two: Lower Leg Stretcher Assembly Place Lower Leg Stretcher between Leg Assemblies aligning predrilled holes. Attach using (4) 3” Hex 1/4” Lags. Repeat process for other Lower Leg Stretcher. (Right Picture)
Step Three: Upper Leg Stretcher Assembly Place Upper Leg Stretcher between Leg Assemblies aligning predrilled holes. Attach using (4) 3” Hex 1/4” Lags. Repeat process for other Upper Leg Stretcher. (Left Picture)
Step Four: Mid Umbrella Stretcher Assembly Place Mid Umbrella Stretcher between Upper Leg Stretchers aligning pre-drilled holes. Attach using (4) 3” Hex 1/4” Lags. (Right Picture)
WARRANTY QUESTIONS OR COMMENTS PLEASE CALL TOLL FREE AT 1-800-809-3114 1
Step Five: Long Apron Assembly Place Long Aprons along Leg Assemblies aligning pre-drilled holes (Left Picture). Attach using (4) 3” Hex 1/4” Lags.
Step Six: Short Apron Assembly Place Short Aprons in between Long Aprons aligning pre-drilled holes. Attach using (4) 3” Hex 1/4” Lags. (Right Picture)
Step Seven: Base Assembly Place Table Top face down on a clean flat surface. Place Base Assembly upside down on to the Table Top. Center Base Assembly within the Table Top. Attach using (10) 3/4” Pan Head Screws. (Left Picture)
Step Eight: Umbrella Securing If needed Insert (2) Thumb Screws into threaded insert nuts, which are in the Mid Umbrella Stretcher. This allows for securing of an Umbrella.