(AC1007 Video Module) Mounting Bracket ... - Home Controls
INSTRUCTION / INSTALLATION SHEET One Bay Module Mounting Bracket / One Bay Horizontal Module Mounting Bracket 301 Fulling Mill Road, Suite G Middletown, PA 17057 Phone (800) 321-2343 / Fax (717) 702-2546 www.onqlegrand.com
IS-0350 Rev. O
1. INTRODUCTION
Figure 1
The On-Q/Legrand One Bay Module Mounting Bracket (P/N 364890-01) and One Bay Horizontal Module Mounting Bracket (P/N AC1007) are used to mount bay style modules on a bracket that is easily installed in an On-Q style enclosure.
2. DESCRIPTION The One Bay Module Mounting Bracket and One Bay Horizontal Module Mounting Bracket are designed with two tabs on the left and a push-pin on the right for mounting in the On-Q enclosure (see Figure 1). They also contain four holes used to secure the module to the bracket with the plungers in each corner of the module (see Figure 2). The One Bay Horizontal Module Mounting Bracket is designed to facilitate running coaxial cable from the top of the enclosure to the bracket without a sharp bend radius (see Figure 3).
364890-01
3. INSTALLATION To mount a module on either bracket, pull out the plungers located at each corner of the module and insert the module into the bracket, depressing the plungers to secure the module to the bracket. Then to mount the bracket in the enclosure, insert the bracket into the On-Q style enclosure by inserting the tabs on the bracket into the slots on the left hand side of the enclosure and securing the bracket with the push-pin on the right end of the bracket.
Figure 2
AC1007
Figure 3 module mounting plunger
module mounting plunger enclosure mounting tabs
©Copyright 2006 by On-Q/Legrand All Rights Reserved.
enclosure mounting push-pin
enclosure mounting tabs
enclosure mounting push-pin
Page 1 of 1
IS-0350 Rev. O
1. INTRODUCTION
Figure 1
The On-Q/Legrand One Bay Module Mounting Bracket (P/N 364890-01) and One Bay Horizontal Module Mounting Bracket (P/N AC1007) are used to mount bay style modules on a bracket that is easily installed in an On-Q style enclosure.
2. DESCRIPTION The One Bay Module Mounting Bracket and One Bay Horizontal Module Mounting Bracket are designed with two tabs on the left and a push-pin on the right for mounting in the On-Q enclosure (see Figure 1). They also contain four holes used to secure the module to the bracket with the plungers in each corner of the module (see Figure 2). The One Bay Horizontal Module Mounting Bracket is designed to facilitate running coaxial cable from the top of the enclosure to the bracket without a sharp bend radius (see Figure 3).
364890-01
3. INSTALLATION To mount a module on either bracket, pull out the plungers located at each corner of the module and insert the module into the bracket, depressing the plungers to secure the module to the bracket. Then to mount the bracket in the enclosure, insert the bracket into the On-Q style enclosure by inserting the tabs on the bracket into the slots on the left hand side of the enclosure and securing the bracket with the push-pin on the right end of the bracket.
Figure 2
AC1007
Figure 3 module mounting plunger
module mounting plunger enclosure mounting tabs
©Copyright 2006 by On-Q/Legrand All Rights Reserved.
enclosure mounting push-pin
enclosure mounting tabs
enclosure mounting push-pin
Page 1 of 1
