Anker 2.4G Wireless Mouse LED Replacement

Anker 2.4G Wireless Mouse LED Replacement

Anker 2.4G Wireless Mouse LED Replacement We will be replacing the red led that illuminates the DPI button.

Written By: Colin

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 1 of 6

Anker 2.4G Wireless Mouse LED Replacement

TOOLS:

PARTS:

Phillips #0 Screwdriver (1)

L.E.D. (1)

Soldering Station (1) Desoldering Braid (1)

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 2 of 6

Anker 2.4G Wireless Mouse LED Replacement

Step 1 — LED 

Use screwdriver to gently pry off the stickers marked in red to reveal the location of the 4 screws



Remove the 4 screws to continue.

Step 2

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 3 of 6

Anker 2.4G Wireless Mouse LED Replacement

Step 3



Pry the center of the mouse apart to separate upper and lower housing of the boards.

Step 4 

Remove the wires from the white crimp headers. This will separate the upper and lower housing units of the mouse.

 Pull as far up on the wire as possible, but be careful to avoid ripping the wires.

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 4 of 6

Anker 2.4G Wireless Mouse LED Replacement

Step 5



Take the upper housing of the mouse and remove the two screws (highlighted in red) that hold the board in place.

Step 6 

© iFixit — CC BY-NC-SA

www.iFixit.com

Gently remove board.

Page 5 of 6

Anker 2.4G Wireless Mouse LED Replacement

Step 7



The LED is the red component on this board circled in red.



To remove it, flip the board over and desolder the wired highlighted in orange.



Replace LED with a new LED and resolder into place.

To reassemble your device, follow these instructions in reverse order. This document was last generated on 2017-06-28 04:10:45 AM.

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 6 of 6