SAGM 06 375 6V 375Ah @ 20Hr Polypropylene VRLA AGM / Non-Spillable / Maintenance-Free Maroon No Watering Required 8+ Years Life
MODEL VOLTAGE CAPACITY MATERIAL BATTERY COLOR WATERING IEC 61427
MAINTENANCE-FREE
PRODUCT + PHYSICAL SPECIFICATIONS Model
Terminal Type D
SAGM 06 375
M8/LT
Dimensions B Inches (mm) Length
11.66 (296)
Weight Lbs. F (kg)
Handles
Installation Orientation
114 (52)
Braided Rope
Horizontal and Vertical
Height C
Width
6.94 (176)
16.31 (414)
ELECTRICAL SPECIFICATIONS Voltage
6V
Capacity A Amp-Hours (Ah)
Energy kWh
10-Hr
20-Hr
48-Hr
72-Hr
100-Hr
20-Hr
329
375
389
394
400
2.25
Internal Resistance (mΩ)
Short Circuit Current (A)
1.7
3650
CHARGING INSTRUCTIONS Charger Voltage Settings (at 77°F/25°C) System Voltage
6V
8V
12V
Bulk
24V
36V
48V
20% of C20
Absorption Charge (2.40 VPC)
7.20
9.60
14.40
28.80
43.20
57.60
Float Charge (2.25 VPC)
6.75
9.00
13.50
27.00
40.50
54.00
Do not install or charge batteries in a sealed or non-ventilated compartment. Constant under or overcharging will damage the battery and shorten its life as with any battery.
CHARGING TEMPERATURE COMPENSATION
STATE OF CHARGE MEASURE OF OPEN-CIRCUIT VOLTAGE
Add
Subtract
0.005 volt per cell for every 1°C below 25°C 0.0028 volt per cell for every 1°F below 77°F
0.005 volt per cell for every 1°C above 25°C 0.0028 volt per cell for every 1°F above 77°F
OPERATIONAL DATA Operating Temperature
Self Discharge
-4°F to 122°F (-20°C to 50°C) Less than 3% per month depending on At temperatures below 32°F (0°C) storage temperature conditions maintain a state of charge greater than 60%
Percentage Charge
Cell
6 Volt
100
2.14
6.42
75
2.09
6.27
50
2.04
6.12
25
1.99
5.97
0
1.94
5.82
TROJAN
SINCE 1925 QUALITY
Designed in compliance with applicable BCI, DIN, BS and IEC standards. Tested in compliance to BCI and IEC standards.
INITIAL RELEASE; ECO4501 REMOVE CROSS SECTION SIDE VIEW; MOVE DIMENSION; COR4771 REMOVING LETTERS FROM VENTS; COR4788
1. ALL DIMENSIONS ARE NOMINAL. 2. HEAT SEAL MELT = 0.100
D
D
G
C
SCALE 0.400
C 16.31 (414) HEIGHT
15.97 (406)
F
B
15.97 (406)
16.31 (414) HEIGHT
B
B
E
THIS DRAWING AND DATA EMBODY PROPRIETARY INFORMATION WHICH IS THE CONFIDENTIAL PROPERTY OF TROJAN BATTERY COMPANY WHICH SHALL NOT BE COPIED, REPRODUCED DISCLOSED TO OTHERS OR USED IN WHOLE OR PART FOR ANY PURPOSE WITHOUT THE EXPRESS WRITTEN PERMISSION OF TROJAN BATTERY CO. THIS DRAWING IS LOANED IN CONFIDENCE WITH THE UNDERSTANDING THAT IT SHALL BE RETURNED ON DEMAND
6.94 (176) WIDTH
11.66 (296) LENGTH
12380 CLARK ST. SANTA FE SPRINGS, CA 90670 5194 MINOLA DR. LITHONIA, GA 30038
A
A
11.59 (294)
7
6
TERMINAL CONFIGURATIONS
UNCONTROLLED COPY WHEN DOWNLOADED or PRINTEDCheck MASTER DOCUMENT LOG to verify that this document/drawing is current prior to use
D
5
SCALE 0.
C
6.88 (175)
D
UNLESS OTHERWISE SPECIFICED TOLERANCES ARE:
11.59 (294)
7 4
63
X.X 0.02" X.XX 0.01" X.XXX 0.005" ANGLES = 0 30'
5
TITLE
DWN BY
L16 AGM MKTG M8 6.88 (175)
A. SAN
SCALE
CHK
UNLESS OTHERWISE SPECIFICED TOLERANCES ARE:
APPVD
CSIZE=DWG SCALE
DATE
DWG NO
12-5-2014
721024
4
REV
C
D
X.X 0.02" X.XX 0.01" X.XXX 0.005" ANGLES = 0 30'
3
D
UNCONTROLLED COPY WHEN DOWNLOADED or PRINTEDCheck MASTER DOCUMENT LOG to verify that this document/drawing is current prior to use
M8
M8 with LT Adapter (adapter provided but not installed)
SCALE 0.400
C 15.97 (406)
Battery Height with Terminal in Inches (mm) 15.97 (406)
Battery Height with Terminal in16.31 Inches (mm) (414) 17.47 (444)
HEIGHT
Torque Values: in-lb (Nm)
Connection to M8: 85 – 90 (10-11) Connection to LT: 65 – 75 (7.5 – 8.5)
B Torque Values: in-lb (Nm)
Bolt: 85 – 90 (10 – 11)
Bolt Size M8 x 1.25
A. The amount of amp-hours (Ah) a battery can deliver when discharged at a constant rate at 86°F (30°C) for all rates and maintain a C. voltage above 1.75 V/cell. Capacities are based on peak performance. D. A B. Dimensions may vary depending on type of handle or terminal. Batteries should be mounted with 0.5 inches (12.7 mm) spacing 11.59 (294) E. minimum. F. 7
Height taken from bottom of the battery to the highest point on the battery. Heights may vary depending on type of terminal. UNLESS OTHERWISE Terminal images are representative only. SPECIFICED TOLERANCES ARE: 6.88 (175) A boost charge should be performed every 6 months when batteries are in storage. Weight may vary.
6
5
4
3
X.X 0.02" X.XX 0.01" X.XXX 0.005" ANGLES = 0 30'
12380 CLARK ST. SA 5194 MINOLA DR. LIT
TITLE
DWN BY DATE
UNCONTROLLED COPY WHEN DOWNLOADED or PRINTEDCheck MASTER DOCUMENT LOG to verify that this document/drawing is current prior to use