General Electric Telephone 2-9710A 9V Base Battery ... - The-Eye.eu!
General Electric Telephone 2-9710A 9V Base Battery Replacement
General Electric Telephone 2-9710A 9V Base Battery Replacement Replace the the battery that powers the base
Written By: Norberto Sanchez
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 1 of 4
General Electric Telephone 2-9710A 9V Base Battery Replacement
INTRODUCTION Use this guide to replace the 9 Volt battery that powers the base
TOOLS:
PARTS:
Phillips #1 Screwdriver (1)
9 Volt Alkaline Battery (1)
iFixit Opening Tools (1)
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 2 of 4
General Electric Telephone 2-9710A 9V Base Battery Replacement
Step 1 — Phone Cord
Unplug the device before proceeding.
Remove the phone cord from the phone jack from the base of the headset.
Use a plastic opening tool to remove the phone cord.
Step 2
Remove the phone cord screw cap.
Unscrew the 7.5mm screw.
Remove the screw cap.
Remove the cord from the phone base.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 3 of 4
General Electric Telephone 2-9710A 9V Base Battery Replacement
Step 3 — 9V Base Battery
Use finger to remove the battery cover.
To reassemble your device, follow these instructions in reverse order. This document was last generated on 2017-09-30 07:54:57 PM.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 4 of 4
General Electric Telephone 2-9710A 9V Base Battery Replacement Replace the the battery that powers the base
Written By: Norberto Sanchez
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 1 of 4
General Electric Telephone 2-9710A 9V Base Battery Replacement
INTRODUCTION Use this guide to replace the 9 Volt battery that powers the base
TOOLS:
PARTS:
Phillips #1 Screwdriver (1)
9 Volt Alkaline Battery (1)
iFixit Opening Tools (1)
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 2 of 4
General Electric Telephone 2-9710A 9V Base Battery Replacement
Step 1 — Phone Cord
Unplug the device before proceeding.
Remove the phone cord from the phone jack from the base of the headset.
Use a plastic opening tool to remove the phone cord.
Step 2
Remove the phone cord screw cap.
Unscrew the 7.5mm screw.
Remove the screw cap.
Remove the cord from the phone base.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 3 of 4
General Electric Telephone 2-9710A 9V Base Battery Replacement
Step 3 — 9V Base Battery
Use finger to remove the battery cover.
To reassemble your device, follow these instructions in reverse order. This document was last generated on 2017-09-30 07:54:57 PM.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 4 of 4
