You will also need: 1/2 yard of Binding fabric, and 3 yards of Backing fabric and Batting.
Notes Before You Begin - Please read through all of the instructions before beginning. - All of the seam allowances are 1/4” unless otherwise noted. - WOF is “Width of Fabric” which is 40” minimum, unless otherwise noted. - Press all seam allowances open after each seam is sewn, unless otherwise noted. - Remember to measure twice and cut once!
Cutting Instructions Panel A - Trim the Baseball Field panel to 44-1/2” x 36”. Fabric B - Cut two strips 7-1/2” x WOF, then subcut into fourteen rectangles 5” x 7-1/2”. Fabric C - Cut two strips 7-1/2” x WOF, then subcut into fourteen rectangles 5” x 7-1/2”. Fabric D - Cut four strips 3” x WOF.
For individual use only - Not for resale Copyright 2014, Robert Kaufman
page 2
Quilt Assembly Instructions 1. Sew two Fabric D strips lengthwise to the top and bottom of Panel A. Once you have sewn and pressed your seams, true-up Fabric D to be the same length as Panel A. Note: Your strips should be just long enough to fit on your panel. If you find they aren’t, you may either trim down the sides of the panel to match, or add a small length to your strips.
2. Sew the remaining two Fabric D strips to the left and right side of Panel A. Trim excess from Fabric D. 3. Sew three Fabric B and four Fabric C rectangles, short sides together, beginning with Fabric C and alternating C/B/C/B/C/B/C to create Border C/B. Repeat to make a second Border C/B. 4. Sew the borders lengthwise to the top and bottom of the quilt top. 5. Repeat steps 3 and 4 with the remaining Fabric B and C rectangles, but begin with Fabric B and alternate B/C/B/C/B/C/B to make Border B/C. Make 2 borders. 6. Sew borders lengthwise to the left and right sides of the quilt top. True up Borders C/B to match Borders B/C.