HP ProBook 645 Keyboard Replacement
HP ProBook 645 Keyboard Replacement
HP ProBook 645 Keyboard Replacement Instructional documentation on Keyboard replacement of keyboard of HP Pro Book 645.
Written By: Doug
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 1 of 4
HP ProBook 645 Keyboard Replacement
TOOLS: Phillips #2 Screwdriver (1) Small Plastic Spudger (1)
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 2 of 4
HP ProBook 645 Keyboard Replacement
Step 1 — Remove 2 screws
© iFixit — CC BY-NC-SA
www.iFixit.com
Remove the two screws at the two indicated locations with the phillips head screw driver.
Page 3 of 4
HP ProBook 645 Keyboard Replacement
Step 2 — Flip unit over and open lid.
Take a spudger tool and pry the keyboard down toward the mouse pad and up toward you. After you raise the keyboard there are tabs at the bottom. Pull the keyboard away from you, and it will dislodge.
Step 3 — Ribbon Removal
1. Remove ribbon by flipping the black tab up and gently pulling on the ribbon.
2. This ribbon has no tab, gently pull on until it comes loose. To reinsert. Line it up carefully as not to damage the ribbon, and push gently.
To reassemble your device, follow these instructions in reverse order. This document was last generated on 2017-06-21 02:58:44 PM.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 4 of 4
HP ProBook 645 Keyboard Replacement Instructional documentation on Keyboard replacement of keyboard of HP Pro Book 645.
Written By: Doug
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 1 of 4
HP ProBook 645 Keyboard Replacement
TOOLS: Phillips #2 Screwdriver (1) Small Plastic Spudger (1)
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 2 of 4
HP ProBook 645 Keyboard Replacement
Step 1 — Remove 2 screws
© iFixit — CC BY-NC-SA
www.iFixit.com
Remove the two screws at the two indicated locations with the phillips head screw driver.
Page 3 of 4
HP ProBook 645 Keyboard Replacement
Step 2 — Flip unit over and open lid.
Take a spudger tool and pry the keyboard down toward the mouse pad and up toward you. After you raise the keyboard there are tabs at the bottom. Pull the keyboard away from you, and it will dislodge.
Step 3 — Ribbon Removal
1. Remove ribbon by flipping the black tab up and gently pulling on the ribbon.
2. This ribbon has no tab, gently pull on until it comes loose. To reinsert. Line it up carefully as not to damage the ribbon, and push gently.
To reassemble your device, follow these instructions in reverse order. This document was last generated on 2017-06-21 02:58:44 PM.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 4 of 4
