ION TP5 QS Guide
ION TP5 POS TERMINAL
QUICKSTART GUIDE Connect Power & Additional Cables - Remove the terminal's back cover by sliding the plastic cover up and out - Connect the power supply cable to the GREEN 'DC 19V in' port on the terminal - Loop the power cable - Connect other cables (see port diagram)
1
2
Lock Rear Cover (optional/ select models) - After all cables have been connected to the terminal, attach the rear cover - Set the terminal face down on a soft material to prevent damage - Use a coin or a screwdriver to turn the two screws to the ?LOCK?position
3
Port Diagram (see step 1 to access) Cash Drawer
LAN
USB1 USB2
COM
USB3
4
DC 19V in
Install Receipt Paper (select models) - Press the paper door release button to open the door - Insert paper roll thermal side up - Close the door with the end of the paper coming out of the door - Tear off excess paper
Power On Terminal - The Power button is located on bottom left side of the display
Plug in your USB devices to the BLUE ports. Plug in your network cable to the RED LAN port. Plug in your cash drawer into the ORANGE 'Cash Drawer' port. Caution: Connecting the wrong cable to a port may cause physical or electrical damage that is not covered under warranty
Visit pos-x.com/ support for online support articles & drivers
ONLINE CHAT
PHONE SUPPORT
EMAIL SUPPORT
www.pos-x.com
360.302.2222
[email protected]
QUICKSTART GUIDE Connect Power & Additional Cables - Remove the terminal's back cover by sliding the plastic cover up and out - Connect the power supply cable to the GREEN 'DC 19V in' port on the terminal - Loop the power cable - Connect other cables (see port diagram)
1
2
Lock Rear Cover (optional/ select models) - After all cables have been connected to the terminal, attach the rear cover - Set the terminal face down on a soft material to prevent damage - Use a coin or a screwdriver to turn the two screws to the ?LOCK?position
3
Port Diagram (see step 1 to access) Cash Drawer
LAN
USB1 USB2
COM
USB3
4
DC 19V in
Install Receipt Paper (select models) - Press the paper door release button to open the door - Insert paper roll thermal side up - Close the door with the end of the paper coming out of the door - Tear off excess paper
Power On Terminal - The Power button is located on bottom left side of the display
Plug in your USB devices to the BLUE ports. Plug in your network cable to the RED LAN port. Plug in your cash drawer into the ORANGE 'Cash Drawer' port. Caution: Connecting the wrong cable to a port may cause physical or electrical damage that is not covered under warranty
Visit pos-x.com/ support for online support articles & drivers
ONLINE CHAT
PHONE SUPPORT
EMAIL SUPPORT
www.pos-x.com
360.302.2222
[email protected]
