premium series mighty-mate
SECTION: 2.15.045 FM2985 1116 Supersedes 1016
Your Peace of Mind is Our Top Priority ® ®
Product information presented here reflects conditions at time of publication. Consult factory regarding discrepancies or inconsistencies.
TECHNICAL DATA SHEET
PREMIUM SERIES MIGHTY-MATE Cast Iron Model 95 Submersible Sump / Dewatering Pumps
MATERIALS
PUMP
MOTOR
PRODUCT SPECIFICATIONS Horse Power
1/2
Voltage
115
Phase
1 Ph
Hertz
60 Hz
RPM
3450
Type
Permanent split capacitor
Insulation
Class B
Amps
10.5
Operation
Automatic
Auto On/Off Points
9-1/2" (24 cm) / 2-1/2" (6.4 cm)
Discharge Size
1-1/2" NPT
Solids Handling
1/2" (12 mm) spherical solids
Cord Length
15' (4.6 m)
Cord Type
UL listed, 3-wire, grounded plug
Max. Head
26' (7.9 m)
Max. Flow Rate
80 GPM (303 LPM)
Max. Operating Temp.
130° F (54° C)
Cooling
Oil filled
Motor Protection
Auto reset thermal overload
Cap
Cast iron
Motor Housing
Cast iron
Pump Housing
Cast iron
Base
Cast iron
Upper Bearing
Sleeve bearing
Lower Bearing
Ball bearing
Mechanical Seals
Carbon and ceramic
Impeller Type
Non-clogging vortex
Impeller
Engineered thermoplastic
Hardware
Stainless steel
Motor Shaft
AISI 1215 cold rolled steel
Gasket
Neoprene
6 7/32" (158 mm) 3 7/8" (98 mm)
4 5/8" (117 mm) 3 7/8" (98 mm)
4" (102 mm)
1 1/2" NPT
12 1/8" (308 mm)
5 3/8" (137 mm)
NOTE: See model comparison chart for specific details.
R
Tested to Standard UL778 and Certified to CSA Standard C22.2 No. 108
© Copyright 2016 Zoeller® Co. All rights reserved. 502-778-2731 | 800-928-7867 | 3649 Cane Run Road | Louisville, KY 40211-1961 | www.zoeller.com
SK3129
FLOW PER MINUTE
FEET
METERS
TOTAL DYNAMIC HEAD/FLOW PER MINUTE TOTAL DYNAMIC HEAD EFFLUENT AND DEWATERING
PUMP PERFORMANCE CURVE MODEL 95
10 30
MODEL
95
Feet Meters 1.5 5 10 3.0 15 4.6 20 6.1 25 7.6 Shut-off Head:
Gal. Liters 80 303 68 257 50 189 28 106 5 19 26.0 ft (7.9 m)
TOTAL DYNAMIC HEAD
8
25 20
6
15 4 10 2
5
0 10 GALLONS LITERS
0
40
20
30
80
40
120
50
160
200
70
60 240
90
80 280
320
FLOW PER MINUTE 154422
Model M95
MODEL COMPARISON
CERTIFICATIONS
Seal
Mode
Volts
Ph
Amps
HP
Hz
Lbs
Kg
Simplex
Duplex
cCSAus
Single
Auto
115
1
10.5
1/2
60
38
17
1
---
Y
* Single piggyback switch included.
SPECIAL MODEL FEATURES Has a lighted plug, cast iron switch case, motor and pump housing, a cast iron base, and a thermoplastic impeller. Optional pump stand (P/N 10-2421). Integral float-operated electro-mechanical switch, no external control required.
CAUTION
All installation of controls, protection devices and wiring should be done by a qualified licensed electrician. All electrical and safety codes should be followed including the most recent National Electrical Code (NEC) and the Occupational Safety and Health Act (OSHA).
© Copyright 2016 Zoeller® Co. All rights reserved. 502-778-2731 | 800-928-7867 | 3649 Cane Run Road | Louisville, KY 40211-1961 | www.zoeller.com
Your Peace of Mind is Our Top Priority ® ®
Product information presented here reflects conditions at time of publication. Consult factory regarding discrepancies or inconsistencies.
TECHNICAL DATA SHEET
PREMIUM SERIES MIGHTY-MATE Cast Iron Model 95 Submersible Sump / Dewatering Pumps
MATERIALS
PUMP
MOTOR
PRODUCT SPECIFICATIONS Horse Power
1/2
Voltage
115
Phase
1 Ph
Hertz
60 Hz
RPM
3450
Type
Permanent split capacitor
Insulation
Class B
Amps
10.5
Operation
Automatic
Auto On/Off Points
9-1/2" (24 cm) / 2-1/2" (6.4 cm)
Discharge Size
1-1/2" NPT
Solids Handling
1/2" (12 mm) spherical solids
Cord Length
15' (4.6 m)
Cord Type
UL listed, 3-wire, grounded plug
Max. Head
26' (7.9 m)
Max. Flow Rate
80 GPM (303 LPM)
Max. Operating Temp.
130° F (54° C)
Cooling
Oil filled
Motor Protection
Auto reset thermal overload
Cap
Cast iron
Motor Housing
Cast iron
Pump Housing
Cast iron
Base
Cast iron
Upper Bearing
Sleeve bearing
Lower Bearing
Ball bearing
Mechanical Seals
Carbon and ceramic
Impeller Type
Non-clogging vortex
Impeller
Engineered thermoplastic
Hardware
Stainless steel
Motor Shaft
AISI 1215 cold rolled steel
Gasket
Neoprene
6 7/32" (158 mm) 3 7/8" (98 mm)
4 5/8" (117 mm) 3 7/8" (98 mm)
4" (102 mm)
1 1/2" NPT
12 1/8" (308 mm)
5 3/8" (137 mm)
NOTE: See model comparison chart for specific details.
R
Tested to Standard UL778 and Certified to CSA Standard C22.2 No. 108
© Copyright 2016 Zoeller® Co. All rights reserved. 502-778-2731 | 800-928-7867 | 3649 Cane Run Road | Louisville, KY 40211-1961 | www.zoeller.com
SK3129
FLOW PER MINUTE
FEET
METERS
TOTAL DYNAMIC HEAD/FLOW PER MINUTE TOTAL DYNAMIC HEAD EFFLUENT AND DEWATERING
PUMP PERFORMANCE CURVE MODEL 95
10 30
MODEL
95
Feet Meters 1.5 5 10 3.0 15 4.6 20 6.1 25 7.6 Shut-off Head:
Gal. Liters 80 303 68 257 50 189 28 106 5 19 26.0 ft (7.9 m)
TOTAL DYNAMIC HEAD
8
25 20
6
15 4 10 2
5
0 10 GALLONS LITERS
0
40
20
30
80
40
120
50
160
200
70
60 240
90
80 280
320
FLOW PER MINUTE 154422
Model M95
MODEL COMPARISON
CERTIFICATIONS
Seal
Mode
Volts
Ph
Amps
HP
Hz
Lbs
Kg
Simplex
Duplex
cCSAus
Single
Auto
115
1
10.5
1/2
60
38
17
1
---
Y
* Single piggyback switch included.
SPECIAL MODEL FEATURES Has a lighted plug, cast iron switch case, motor and pump housing, a cast iron base, and a thermoplastic impeller. Optional pump stand (P/N 10-2421). Integral float-operated electro-mechanical switch, no external control required.
CAUTION
All installation of controls, protection devices and wiring should be done by a qualified licensed electrician. All electrical and safety codes should be followed including the most recent National Electrical Code (NEC) and the Occupational Safety and Health Act (OSHA).
© Copyright 2016 Zoeller® Co. All rights reserved. 502-778-2731 | 800-928-7867 | 3649 Cane Run Road | Louisville, KY 40211-1961 | www.zoeller.com
