Rhino-Rack - Fitting Instructions - S604 - Tie Down Eye Nuts
CONTROLLED
S604 Tie Down Eye Nuts Important:
Please read these instructions carefully prior to installation. Please refer to your fitting instruction to ensure that the bracket is installed in the correct locations. Check the contents of kit before commencing fitment and report any discrepancies. Place these instructions in the vehicle’s glove box after installation is complete.
Parts List Item 1 2 3 4
Component Name M8 Eye Nut M8 HDPE Flat Washer M8 x 16mm T-Bolt Fitting Instruction
Qty. 2 2 2 1
1
Slide and locate bolt in the cross bar.
3
Cut buffer strip to suit and place in cross bar.
1
Part No. C079 W060 B222 R580
2 3
2
Locate bolt on cross bar. Place a flat washer and turn eye nut onto the end of each bolt. Tighten with the shank of a screwdriver. For secure tie off points ensure the eye nut hole faces the front and rear of the vehicle.
Rhino-Rack 3 Pike Street, Rydalmere, NSW 2116, Australia. (Ph) (02) 9638 4744 (Fax) (02) 9638 4822 Prepared By: Peter Luu Authorised By: Chris Murty
Document No: R580 Issue No: 02 Issue Date: 3/03/2016
These instructions remain the property of Rhino-Rack Australia Pty Ltd and may not be used or changed for any other purpose than intended.
S604 Tie Down Eye Nuts Important:
Please read these instructions carefully prior to installation. Please refer to your fitting instruction to ensure that the bracket is installed in the correct locations. Check the contents of kit before commencing fitment and report any discrepancies. Place these instructions in the vehicle’s glove box after installation is complete.
Parts List Item 1 2 3 4
Component Name M8 Eye Nut M8 HDPE Flat Washer M8 x 16mm T-Bolt Fitting Instruction
Qty. 2 2 2 1
1
Slide and locate bolt in the cross bar.
3
Cut buffer strip to suit and place in cross bar.
1
Part No. C079 W060 B222 R580
2 3
2
Locate bolt on cross bar. Place a flat washer and turn eye nut onto the end of each bolt. Tighten with the shank of a screwdriver. For secure tie off points ensure the eye nut hole faces the front and rear of the vehicle.
Rhino-Rack 3 Pike Street, Rydalmere, NSW 2116, Australia. (Ph) (02) 9638 4744 (Fax) (02) 9638 4822 Prepared By: Peter Luu Authorised By: Chris Murty
Document No: R580 Issue No: 02 Issue Date: 3/03/2016
These instructions remain the property of Rhino-Rack Australia Pty Ltd and may not be used or changed for any other purpose than intended.
