Tapwave T2907US Zodiac 2 Battery Replacement

Tapwave T2907US Zodiac 2 Battery Replacement

Tapwave T2907US Zodiac 2 Battery Replacement Replacing dead battery and installing new battery.

Written By: Daniel Wiseman

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 1 of 4

Tapwave T2907US Zodiac 2 Battery Replacement

INTRODUCTION Use this guide when you need to replace the battery because it has died.

TOOLS: Tweezers (1)

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 2 of 4

Tapwave T2907US Zodiac 2 Battery Replacement

Step 1 — Back Cover 

Remove the four Torx T5 screws from the back panel.



Wedge a spudger in between the front and back panel.



Apply leverage downwards to the spudger in order to remove the back panel.

Step 2

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 3 of 4

Tapwave T2907US Zodiac 2 Battery Replacement

Step 3 — Battery 

Slide the battery out from under the brown wire-tape. 

Be careful of the wires still connected to the other end of the battery. Do not pull or damage may occur.

Step 4 

Slowly pull the white plug from its receptor. Grasp its sides firmly with a pair of tweezers and gently wiggle from side to side.

This document was last generated on 2017-06-24 06:34:21 PM.

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 4 of 4