VTech Record and Learn KidiStudio Whammy Bar Replacement
VTech Record and Learn KidiStudio Whammy Bar Replacement
VTech Record and Learn KidiStudio Whammy Bar Replacement This guide shows how to replace the Whammy Bar on the Vtech Record and Learn KidiStudio.
Written By: Shaina Carbonel
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 1 of 4
VTech Record and Learn KidiStudio Whammy Bar Replacement
INTRODUCTION This guide provides knowledge on how to replace the Whammy bar on the 2014 Vtech Record and Learn KidiStudio.
TOOLS:
PARTS:
Phillips #2 Screwdriver (1)
Whammy Bar Replacement (1)
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 2 of 4
VTech Record and Learn KidiStudio Whammy Bar Replacement
Step 1 — Whammy Bar
Unscrew 11 PH2 screws (7 mm).
Remove black plastic backing.
Remove the batteries from the toy before beginning replacement of the whammy bar.
Step 2
Remove PH2 screw (5 mm) from yellow/gold colored circuit board and pull back to access the whammy component.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 3 of 4
VTech Record and Learn KidiStudio Whammy Bar Replacement
Step 3
Remove 3 PH2 (5 mm) screws connected to the whammy bar component.
Remove blue piece from back of the device. This will free the whammy bar. Replace the whammy bar with new part.
To reassemble your device, follow these instructions in reverse order. This document was last generated on 2017-06-19 09:07:24 AM.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 4 of 4
VTech Record and Learn KidiStudio Whammy Bar Replacement This guide shows how to replace the Whammy Bar on the Vtech Record and Learn KidiStudio.
Written By: Shaina Carbonel
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 1 of 4
VTech Record and Learn KidiStudio Whammy Bar Replacement
INTRODUCTION This guide provides knowledge on how to replace the Whammy bar on the 2014 Vtech Record and Learn KidiStudio.
TOOLS:
PARTS:
Phillips #2 Screwdriver (1)
Whammy Bar Replacement (1)
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 2 of 4
VTech Record and Learn KidiStudio Whammy Bar Replacement
Step 1 — Whammy Bar
Unscrew 11 PH2 screws (7 mm).
Remove black plastic backing.
Remove the batteries from the toy before beginning replacement of the whammy bar.
Step 2
Remove PH2 screw (5 mm) from yellow/gold colored circuit board and pull back to access the whammy component.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 3 of 4
VTech Record and Learn KidiStudio Whammy Bar Replacement
Step 3
Remove 3 PH2 (5 mm) screws connected to the whammy bar component.
Remove blue piece from back of the device. This will free the whammy bar. Replace the whammy bar with new part.
To reassemble your device, follow these instructions in reverse order. This document was last generated on 2017-06-19 09:07:24 AM.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 4 of 4
