Wen 2307 Fan Replacement

Wen 2307 Fan Replacement

Wen 2307 Fan Replacement This guide shows how to replace your Wen 2307 motor fan.

Scritto Da: Joshua Bowery

© iFixit — CC BY-NC-SA

it.iFixit.com

Pagina 1 di 8

Wen 2307 Fan Replacement

INTRODUZIONE If your device is over heating you may need to replace your motor fan. This guide will show you how.

STRUMENTI: Flathead 3/32" or 2.5 mm Screwdriver (1) Phillips #2 Screwdriver (1)

© iFixit — CC BY-NC-SA

it.iFixit.com

Pagina 2 di 8

Wen 2307 Fan Replacement

Passo 1 — Front Panel 

Unscrew the locking sleeve.



Remove the hanging clip.

Passo 2

© iFixit — CC BY-NC-SA

it.iFixit.com

Pagina 3 di 8

Wen 2307 Fan Replacement

Passo 3



Unscrew the six 8mm PH2 screws.

Passo 4 

© iFixit — CC BY-NC-SA

it.iFixit.com

While pressing the spindle lock button, unscrew the collet nut and remove it along with the brass collet.

Pagina 4 di 8

Wen 2307 Fan Replacement

Passo 5 

To remove the front panel, pry the device apart while holding the device with the other hand.

 The front panel should come out easily.

Passo 6 — Speed Adjustment Assembly 

© iFixit — CC BY-NC-SA

it.iFixit.com

Remove the connected wiring from the circuit board.

Pagina 5 di 8

Wen 2307 Fan Replacement

Passo 7 

Remove the single 4mm screw retaining the circuit board.



Gently pry the circuit board from the back piece.

Passo 8

© iFixit — CC BY-NC-SA

it.iFixit.com

Pagina 6 di 8

Wen 2307 Fan Replacement

Passo 9 — Motor 

Gently pull motor assembly out of the panel.

Passo 10

 Motor separates into two pieces.

© iFixit — CC BY-NC-SA

it.iFixit.com

Pagina 7 di 8

Wen 2307 Fan Replacement

Passo 11 — Fan 

The fan assembly is attached to the rotor beam, it can be disassembled to change the fan by simply pulling off the pieces.

To reassemble your device, follow these instructions in reverse order. Questo documento è stato generato l'ultima volta su 2017-09-13 06:36:48 AM.

© iFixit — CC BY-NC-SA

it.iFixit.com

Pagina 8 di 8