Dremel 7300 MiniMite Cordless Collet Replacement
Dremel 7300 MiniMite Cordless Collet Replacement
Dremel 7300 MiniMite Cordless Collet Replacement This guide shows how to replace the collet nut assembly on the Dremel. It doesn't require any prerequisite steps or tools.
Written By: Kat
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 1 of 4
Dremel 7300 MiniMite Cordless Collet Replacement
INTRODUCTION If you need to replace the collet nut or collet itself, this is the guide for you.
TOOLS: Collet Wrench (1) It comes with the device.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 2 of 4
Dremel 7300 MiniMite Cordless Collet Replacement
Step 1 — Collet
The device comes with a small black wrench to tighten the collet nut, during reassembly or changing the bits.
Press the blue button and hold it down.
Unscrew the collet nut, with your fingers (as if you were going to change the bit).
Continue until the collet nut comes completely off of the Dremel.
Step 2
Once the collet nut is off, you can remove the collet. It is the silver part that grips the bit when the collet nut tightens on it.
The collet itself may be in the shaft, or come off with the nut.
To reassemble your device, follow these instructions in reverse order. This document was last generated on 2017-06-22 05:05:32 PM.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 3 of 4
Dremel 7300 MiniMite Cordless Collet Replacement
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 4 of 4
Dremel 7300 MiniMite Cordless Collet Replacement This guide shows how to replace the collet nut assembly on the Dremel. It doesn't require any prerequisite steps or tools.
Written By: Kat
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 1 of 4
Dremel 7300 MiniMite Cordless Collet Replacement
INTRODUCTION If you need to replace the collet nut or collet itself, this is the guide for you.
TOOLS: Collet Wrench (1) It comes with the device.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 2 of 4
Dremel 7300 MiniMite Cordless Collet Replacement
Step 1 — Collet
The device comes with a small black wrench to tighten the collet nut, during reassembly or changing the bits.
Press the blue button and hold it down.
Unscrew the collet nut, with your fingers (as if you were going to change the bit).
Continue until the collet nut comes completely off of the Dremel.
Step 2
Once the collet nut is off, you can remove the collet. It is the silver part that grips the bit when the collet nut tightens on it.
The collet itself may be in the shaft, or come off with the nut.
To reassemble your device, follow these instructions in reverse order. This document was last generated on 2017-06-22 05:05:32 PM.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 3 of 4
Dremel 7300 MiniMite Cordless Collet Replacement
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 4 of 4
