Eureka AirSpeed Bagless Zuum Vacuum Accessory Holder
Eureka AirSpeed Bagless Zuum Vacuum Accessory Holder Replacement
Eureka AirSpeed Bagless Zuum Vacuum Accessory Holder Replacement If accessory holder breaks, this guide will help you to replace the holder.
Written By: Celina Burchett
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 1 of 4
Eureka AirSpeed Bagless Zuum Vacuum Accessory Holder Replacement
INTRODUCTION If the accessory holder is no longer able to hold the multiple tools associated with the vacuum, this guide outlines the its replacement.
TOOLS: T15 Security Torx Screwdriver (1)
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 2 of 4
Eureka AirSpeed Bagless Zuum Vacuum Accessory Holder Replacement
Step 1 — Hose
On the back of the vacuum, pull the handle connected to the hose away from the vacuum.
Step 2
Grasp the thick smooth collar at the bottom of the hose and twist left (counterclockwise) to remove the hose.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 3 of 4
Eureka AirSpeed Bagless Zuum Vacuum Accessory Holder Replacement
Step 3 — Accessory Holder
Using a T15 Torx Security Screwdriver, remove the screw on each side of the indention in which the hose normally rests.
Upon removal of the two screws, the accessory holder can be removed from the vacuum body.
Step 4
To reassemble your device, follow these instructions in reverse order. This document was last generated on 2017-06-23 01:37:11 AM.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 4 of 4
Eureka AirSpeed Bagless Zuum Vacuum Accessory Holder Replacement If accessory holder breaks, this guide will help you to replace the holder.
Written By: Celina Burchett
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 1 of 4
Eureka AirSpeed Bagless Zuum Vacuum Accessory Holder Replacement
INTRODUCTION If the accessory holder is no longer able to hold the multiple tools associated with the vacuum, this guide outlines the its replacement.
TOOLS: T15 Security Torx Screwdriver (1)
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 2 of 4
Eureka AirSpeed Bagless Zuum Vacuum Accessory Holder Replacement
Step 1 — Hose
On the back of the vacuum, pull the handle connected to the hose away from the vacuum.
Step 2
Grasp the thick smooth collar at the bottom of the hose and twist left (counterclockwise) to remove the hose.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 3 of 4
Eureka AirSpeed Bagless Zuum Vacuum Accessory Holder Replacement
Step 3 — Accessory Holder
Using a T15 Torx Security Screwdriver, remove the screw on each side of the indention in which the hose normally rests.
Upon removal of the two screws, the accessory holder can be removed from the vacuum body.
Step 4
To reassemble your device, follow these instructions in reverse order. This document was last generated on 2017-06-23 01:37:11 AM.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 4 of 4
