Fujifilm FinePix Z90 Lens cover/case Replacement
Fujifilm FinePix Z90 Lens cover/case Replacement
Fujifilm FinePix Z90 Lens cover/case Replacement This replacement guide is used when the lens cover does not slide up to turn the camera on.
Written By: Sam Clark
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 1 of 4
Fujifilm FinePix Z90 Lens cover/case Replacement
INTRODUCTION If your camera case has scratches or dents, it can be replaced by unscrewing the case of it. You need to take out some screws on the left side, right side and bottom part.
TOOLS: Phillips #000 Screwdriver (1) Magnetic Screw Collector (1)
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 2 of 4
Fujifilm FinePix Z90 Lens cover/case Replacement
Step 1 — Lens cover/case
Use a small #000 Phillips screwdriver to take the screws out. Keep all the screws in a container and the two different types separate.
Remove the two screws on the right side.On the same side there is USB connector, open that little door and unscrew the little screw inside of it.
Step 2
Take the two screws on the left side and the two screws on the bottom of the camera.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 3 of 4
Fujifilm FinePix Z90 Lens cover/case Replacement
Step 3
By now you will have the front case and the back case separated from each other.
To reassemble your device, follow these instructions in reverse order. This document was last generated on 2017-07-09 05:36:22 AM.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 4 of 4
Fujifilm FinePix Z90 Lens cover/case Replacement This replacement guide is used when the lens cover does not slide up to turn the camera on.
Written By: Sam Clark
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 1 of 4
Fujifilm FinePix Z90 Lens cover/case Replacement
INTRODUCTION If your camera case has scratches or dents, it can be replaced by unscrewing the case of it. You need to take out some screws on the left side, right side and bottom part.
TOOLS: Phillips #000 Screwdriver (1) Magnetic Screw Collector (1)
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 2 of 4
Fujifilm FinePix Z90 Lens cover/case Replacement
Step 1 — Lens cover/case
Use a small #000 Phillips screwdriver to take the screws out. Keep all the screws in a container and the two different types separate.
Remove the two screws on the right side.On the same side there is USB connector, open that little door and unscrew the little screw inside of it.
Step 2
Take the two screws on the left side and the two screws on the bottom of the camera.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 3 of 4
Fujifilm FinePix Z90 Lens cover/case Replacement
Step 3
By now you will have the front case and the back case separated from each other.
To reassemble your device, follow these instructions in reverse order. This document was last generated on 2017-07-09 05:36:22 AM.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 4 of 4
