IN-SV04-02 MD-150 200 250 Duratran-Medallion Replacement
MD-150, MD-200, and MD-250 Duratran/Medallion Replacement Tools Required z
6 in 1 screw driver
1. Disconnect power to the dispenser. 2. Remove full lid or manual fill lid from unit. 3. Remove the 2 Knurl screws from top of merchandiser. (See Figure 1) 4. Remove the merchandiser from the unit. (See Figure 2)
FIGURE 1 Knurl Screws
5. Remove the seven screws from around the outer top and bottom edges of the merchandiser. (See Figures 3&4) (The screws are threaded into rubber bumpers inside the merchandiser. This will free the medallion for removal) (See Figure 5) 6. Remove the existing medallion from the merchandiser. (See Figure 6)
1
FIGURE 2
FIGURE 3 3 Bumber Screws on top of merchandiser
Foodservice Group
IN-SV04-02 REV 04/30/04
If you have any questions concerning this bulletin, please contact Manitowoc Beverage Equipment’s Technical Service Department at (800) 367-4233
MD-150, MD-200, and MD-250 Duratran/Medallion Replacement 7. Place the new medallion into the merchandiser. (Be sure the medallion is right side up.) 8. Replace the seven outer screws and bumpers into the merchandiser (Screws go on the outside of the merchandiser and bumpers go inside of the merchandiser. The bumpers are what the screws thread into.) 9. Replace the merchandiser in reverse order.
FIGURE 4
10. Re-install lid.
4 Bumper Screws on bottom of merchandiser 11. Reconnect power to the dispenser.
FIGURE 5
FIGURE 6
Rubber Bumpers
Foodservice Group
IN-SV04-02 REV 04/30/04
If you have any questions concerning this bulletin, please contact Manitowoc Beverage Equipment’s Technical Service Department at (800) 367-4233
6 in 1 screw driver
1. Disconnect power to the dispenser. 2. Remove full lid or manual fill lid from unit. 3. Remove the 2 Knurl screws from top of merchandiser. (See Figure 1) 4. Remove the merchandiser from the unit. (See Figure 2)
FIGURE 1 Knurl Screws
5. Remove the seven screws from around the outer top and bottom edges of the merchandiser. (See Figures 3&4) (The screws are threaded into rubber bumpers inside the merchandiser. This will free the medallion for removal) (See Figure 5) 6. Remove the existing medallion from the merchandiser. (See Figure 6)
1
FIGURE 2
FIGURE 3 3 Bumber Screws on top of merchandiser
Foodservice Group
IN-SV04-02 REV 04/30/04
If you have any questions concerning this bulletin, please contact Manitowoc Beverage Equipment’s Technical Service Department at (800) 367-4233
MD-150, MD-200, and MD-250 Duratran/Medallion Replacement 7. Place the new medallion into the merchandiser. (Be sure the medallion is right side up.) 8. Replace the seven outer screws and bumpers into the merchandiser (Screws go on the outside of the merchandiser and bumpers go inside of the merchandiser. The bumpers are what the screws thread into.) 9. Replace the merchandiser in reverse order.
FIGURE 4
10. Re-install lid.
4 Bumper Screws on bottom of merchandiser 11. Reconnect power to the dispenser.
FIGURE 5
FIGURE 6
Rubber Bumpers
Foodservice Group
IN-SV04-02 REV 04/30/04
If you have any questions concerning this bulletin, please contact Manitowoc Beverage Equipment’s Technical Service Department at (800) 367-4233
