Koosh Vortex Tornado Trigger Replacement
Koosh Vortex Tornado Trigger Replacement
Koosh Vortex Tornado Trigger Replacement Replace the trigger of your Koosh Vortex Tornado.
Written By: Lingbin Meng
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 1 of 5
Koosh Vortex Tornado Trigger Replacement
INTRODUCTION This guide will show you how to replace the trigger of the Koosh Vortex Tornado.
TOOLS: Phillips #1 Screwdriver (1) Spudger (1) Plastic Metal Spudger is preferred
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 2 of 5
Koosh Vortex Tornado Trigger Replacement
Step 1 — Barrel Shield Spring
Remove the fourteen 150 mm Phillips #1 screws on the side of the body.
Pull the shells apart to show the inside of the gun. Set the left shell aside.
Step 2
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 3 of 5
Koosh Vortex Tornado Trigger Replacement
Step 3
Using a spudger, unhook the barrel shield's spring from the base of the gun.
Slide the barrel shield and shield slide off of the gun and set aside.
Step 4 — Trigger
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 4 of 5
Koosh Vortex Tornado Trigger Replacement
Step 5
Slide of the rubber ring and set aside.
Lift the yellow trigger from its pin and set aside.
Step 6
To reassemble your device, follow these instructions in reverse order. This document was last generated on 2017-07-13 01:42:14 AM.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 5 of 5
Koosh Vortex Tornado Trigger Replacement Replace the trigger of your Koosh Vortex Tornado.
Written By: Lingbin Meng
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 1 of 5
Koosh Vortex Tornado Trigger Replacement
INTRODUCTION This guide will show you how to replace the trigger of the Koosh Vortex Tornado.
TOOLS: Phillips #1 Screwdriver (1) Spudger (1) Plastic Metal Spudger is preferred
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 2 of 5
Koosh Vortex Tornado Trigger Replacement
Step 1 — Barrel Shield Spring
Remove the fourteen 150 mm Phillips #1 screws on the side of the body.
Pull the shells apart to show the inside of the gun. Set the left shell aside.
Step 2
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 3 of 5
Koosh Vortex Tornado Trigger Replacement
Step 3
Using a spudger, unhook the barrel shield's spring from the base of the gun.
Slide the barrel shield and shield slide off of the gun and set aside.
Step 4 — Trigger
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 4 of 5
Koosh Vortex Tornado Trigger Replacement
Step 5
Slide of the rubber ring and set aside.
Lift the yellow trigger from its pin and set aside.
Step 6
To reassemble your device, follow these instructions in reverse order. This document was last generated on 2017-07-13 01:42:14 AM.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 5 of 5
