MacBook Pro 13" Unibody Mid 2009 Lower Case Replacement

MacBook Pro 13" Unibody Mid 2009 Lower Case Replacement

MacBook Pro 13" Unibody Mid 2009 Lower Case Replacement Written By: Walter Galan

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 1 of 3

MacBook Pro 13" Unibody Mid 2009 Lower Case Replacement

INTRODUCTION Replace the aluminum bottom case in a MacBook Pro 13" Unibody.

TOOLS:

PARTS:

Phillips #00 Screwdriver (1)

MacBook Pro 13" Unibody Lower Case (1) MacBook Pro 13" Unibody (Model A1278 Mid 2009 Mid 2010) Screw Set (1) Macbook Pro 13" and 15" Unibody (Mid 2009 through Mid 2012) Lower Case Screw Set (1) MacBook and MacBook Pro Unibody Rubber Feet (1)

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 2 of 3

MacBook Pro 13" Unibody Mid 2009 Lower Case Replacement

Step 1 — Lower Case 

Remove the following 10 screws securing the lower case to the MacBook Pro 13" Unibody: 

Seven 3 mm Phillips screws.



Three 13.5 mm Phillips screws.

Step 2 

Slightly lift the lower case and push it toward the rear of the computer to free the mounting tabs.

To reassemble your device, follow these instructions in reverse order. This document was last generated on 2017-06-17 04:24:01 AM.

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 3 of 3