Nokero N222-Huron O-Ring Replacement AWS
Nokero N222-Huron O-Ring Replacement
Nokero N222-Huron O-Ring Replacement Replacing the waterproofing seal on the clear cover.
Written By: Vinny Capone
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 1 of 4
Nokero N222-Huron O-Ring Replacement
INTRODUCTION Keeping your device water-proof is paramount in using it to its full potential. Follow this guide to replace the water-proofing O-ring.
TOOLS: Spudger (1)
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 2 of 4
Nokero N222-Huron O-Ring Replacement
Step 1 — Clear Cover
Grasp the clear cover and the white housing and twist the cover counterclockwise.
The lid may hold fast, but it will come off with some firm twisting.
Step 2
Lift the lid from the device
It may be helpful to use a spudger to pry under the lid if there is difficulty in getting a good grip on the smooth plastic.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 3 of 4
Nokero N222-Huron O-Ring Replacement
Step 3 — O-Ring
Using a plastic spudger, lift the o-ring from the lid
Step 4
Gently stretch the new O-ring and place it in position on the clear cover. Make sure it is flush with the flange and not interfering with the locking threads
To reassemble your device, follow these instructions in reverse order. This document was last generated on 2017-06-19 07:59:12 AM.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 4 of 4
Nokero N222-Huron O-Ring Replacement Replacing the waterproofing seal on the clear cover.
Written By: Vinny Capone
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 1 of 4
Nokero N222-Huron O-Ring Replacement
INTRODUCTION Keeping your device water-proof is paramount in using it to its full potential. Follow this guide to replace the water-proofing O-ring.
TOOLS: Spudger (1)
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 2 of 4
Nokero N222-Huron O-Ring Replacement
Step 1 — Clear Cover
Grasp the clear cover and the white housing and twist the cover counterclockwise.
The lid may hold fast, but it will come off with some firm twisting.
Step 2
Lift the lid from the device
It may be helpful to use a spudger to pry under the lid if there is difficulty in getting a good grip on the smooth plastic.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 3 of 4
Nokero N222-Huron O-Ring Replacement
Step 3 — O-Ring
Using a plastic spudger, lift the o-ring from the lid
Step 4
Gently stretch the new O-ring and place it in position on the clear cover. Make sure it is flush with the flange and not interfering with the locking threads
To reassemble your device, follow these instructions in reverse order. This document was last generated on 2017-06-19 07:59:12 AM.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 4 of 4
