Petzl E03 050 Headlamp Lens Piece Replacement

Report 3 Downloads 130 Views
Petzl E03 050 Headlamp Lens Piece Replacement

Petzl E03 050 Headlamp Lens Piece Replacement This guide will describe the steps necessary to replace a damaged or dulled lens piece.

Written By: Mike

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 1 of 5

Petzl E03 050 Headlamp Lens Piece Replacement

INTRODUCTION Does your headlamp produce dim lighting despite a fresh set of batteries and a bulb? You may need to replace the lens piece - especially if the reflective mirror has become damaged or dull.

PARTS: Petzl E03700 Clear Lens and Reflector Assembly for E03 Micro (1) http://www.karstsports.com/pete0clearle.html#.VGzv1K1HA9U

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 2 of 5

Petzl E03 050 Headlamp Lens Piece Replacement

Step 1 — Extend the Damaged Lens Piece 

Remove the damaged lens piece by rotating the lens piece counterclockwise (left) until the lens piece is fully extended.



Remove the extended lens piece by firmly pulling the lens piece away from the battery housing. Take care to properly dispose of the damaged lens piece.

Step 2 — Remove the Lens Piece

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 3 of 5

Petzl E03 050 Headlamp Lens Piece Replacement

Step 3 — Attach the New Lens Piece 

© iFixit — CC BY-NC-SA

www.iFixit.com

Attach the new lens piece by firmly pressing the open end of the lens piece onto the battery housing.

Page 4 of 5

Petzl E03 050 Headlamp Lens Piece Replacement

Step 4 — Secure the New Lens Piece 

Secure the new lens piece onto the battery housing by turning the lens piece clockwise (right) until the headlamp turns on. You have just successfully replaced the lens piece.

This document was last generated on 2017-07-04 09:57:23 PM.

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 5 of 5