Piecing
Party with Patrick
Hugs & Kisses Teddy 11½ x 22½" banner A fabric kit for creating this quilt is available at PatrickLose.com. These requirements are for non-directional prints.
Appliqué Bear & “O” Background–Blue: Fat Quarter “X” Background & Heart Appliqué–Pink: 6 x 15" Border–Multi-blue: ¼ yard Binding–Muti-stripe: ¼ yard Bear Appliqué–Yellow: 8 x 9" “O” & Bear Muzzle, Foot Pads, Inner Ear Appliqués– Light Blue: 8 x 16" “X” Appliqué–Light Pink: 4 x 8" Backing: 14 x 25" Batting: 14 x 25" Lite Steam-a-Seam 2 fusible adhesive: three 9 x 12" sheets Sulky Tear-Easy stabilizer: one 9 x 9" & four 4 x 4" squares Buttons: Two ¾" for eyes & one ½" for nose
Additional supplies and tools - I used coordinating Sulky® 40wt rayon thread for quilting and satin stitching. - You’ll also need an iron, fabric and paper scissors, and a fine point marker for tracing the templates. Sulky is a registered trademark of Sulky of America.
[email protected] Please visit PatrickLose.com and PatrickLose.blogspot.com
Party with Patrick/April 2015 Hugs & Kisses Teddy An optional machine embroidery appliqué design to help in making this project is available at www.PatrickLose.com under Party with Patrick embroideries!
Instructions 1. Refer to the cutting and piecing page for cutting instructions. 2. Trace the templates onto the paper side of your fusible adhesive leaving approximately ½” between tracings. Trace the dashed stitching and placement lines also, if desired. 3. Roughly cut the templates from the adhesive just outside of the traced line. 4. Place the adhesive templates onto the wrong side of their corresponding appliqué fabrics and fuse in place according to manufacturer’s instructions. 5. Neatly cut the appliqués from the fabrics on the traced template lines. 6. Transfer the dashed stitching lines to the right side of the fabric with a non-permanent pen or pencil, if desired. You can use a light table or daylit window. 7. Peel the paper backing from the appliqués and arrange them on the background pieces. Fuse appliqués into place. 8. Place the Sulky Tear-Easy stabilizer behind the block and satin stitch the raw edges of the appliqués, using Sulky Premium 40 wt rayon thread. Referring to photo and using a satin stitch, stitch paws on marked lines. Using a straight stitch or triple stitch, stitch mouth and paw details on marked line. Remove the stabilizer after stitching. 9. Piece the quilt, as shown on the cutting and piecing page. 10. Sandwich batting between quilt and backing with wrong sides of finished quilt and backing against batting. 11. Quilt as desired. Patrick used a straight stitch, in matching thread, around each appliqué’s satin stitching and in the ditch of all seams. He stitched vertical lines on the bear background area and an echo stitch on “X” and “O” background area. 12. Bind as usual, using 2¼” strips cut from the binding fabric. Sew buttons to Teddy’s face for eyes and nose. Copyright 2015 ™
All Rights Reserved Visit www.patricklose.com
Cutting All seams are stitched at ¼". 1. From the blue fabric, cut one 9½ x 10½" piece for bear background and two 4½ x 4½" squares for the “O” appliqué background. 2. From the pink fabric, cut two 4½ x 4½" squares for “X” appliqué background/ 3. From the multi-blue fabric, cut three 1½ x 40" strips, from these strips cut two 1½ x 20½", two 1½ x 11½", two 1½ x 9½", and two 1½ x 4½" strips for border. 4. From the multi-stripe binding fabric, cut two 2¼ x 40" strips for binding. The remaining fabrics will be used for appliqués and backing.
Piecing
Make 2
Copyright 2015 ™
All Rights Reserved
bear
Trace and cut two “X” & “O” templates, and one of each remaining appliqué template.
Trace Line Placement Line Stitching Line Button Placement
All appliqués are printed in reverse for fusing onto the wrong sides of your appliqué fabrics. Dashed lines indicate placement or overlap of appliqués, or a stitching line.
Copyright 2015 ™
All Rights Reserved Visit www.patricklose.com
Trace Line Stitching Line Button Placement
inner ear inner ear muzzle
left foot pad
right foot pad
trace and cut two of each
heart
Copyright 2015 ™
All Rights Reserved Visit www.patricklose.com
No part of this pattern covered by the copyright hereon may be reproduced in any form by any means including, but not limited to, graphic, electronic, mechanical, photocopying, recording, taping, or information storage and retrieval systems without written permission from Patrick Lose. All finished items produced from this pattern and its instructions are protected by Federal Copyright Law and may not be produced for sale in any form whatsoever without the written consent of Patrick Lose.
Hugs & Kisses Teddy 11½ x 22½" banner A fabric kit for creating this quilt is available at PatrickLose.com. These requirements are for non-directional prints.
Appliqué Bear & “O” Background–Blue: Fat Quarter “X” Background & Heart Appliqué–Pink: 6 x 15" Border–Multi-blue: ¼ yard Binding–Muti-stripe: ¼ yard Bear Appliqué–Yellow: 8 x 9" “O” & Bear Muzzle, Foot Pads, Inner Ear Appliqués– Light Blue: 8 x 16" “X” Appliqué–Light Pink: 4 x 8" Backing: 14 x 25" Batting: 14 x 25" Lite Steam-a-Seam 2 fusible adhesive: three 9 x 12" sheets Sulky Tear-Easy stabilizer: one 9 x 9" & four 4 x 4" squares Buttons: Two ¾" for eyes & one ½" for nose
Additional supplies and tools - I used coordinating Sulky® 40wt rayon thread for quilting and satin stitching. - You’ll also need an iron, fabric and paper scissors, and a fine point marker for tracing the templates. Sulky is a registered trademark of Sulky of America.
[email protected] Please visit PatrickLose.com and PatrickLose.blogspot.com
Party with Patrick/April 2015 Hugs & Kisses Teddy An optional machine embroidery appliqué design to help in making this project is available at www.PatrickLose.com under Party with Patrick embroideries!
Instructions 1. Refer to the cutting and piecing page for cutting instructions. 2. Trace the templates onto the paper side of your fusible adhesive leaving approximately ½” between tracings. Trace the dashed stitching and placement lines also, if desired. 3. Roughly cut the templates from the adhesive just outside of the traced line. 4. Place the adhesive templates onto the wrong side of their corresponding appliqué fabrics and fuse in place according to manufacturer’s instructions. 5. Neatly cut the appliqués from the fabrics on the traced template lines. 6. Transfer the dashed stitching lines to the right side of the fabric with a non-permanent pen or pencil, if desired. You can use a light table or daylit window. 7. Peel the paper backing from the appliqués and arrange them on the background pieces. Fuse appliqués into place. 8. Place the Sulky Tear-Easy stabilizer behind the block and satin stitch the raw edges of the appliqués, using Sulky Premium 40 wt rayon thread. Referring to photo and using a satin stitch, stitch paws on marked lines. Using a straight stitch or triple stitch, stitch mouth and paw details on marked line. Remove the stabilizer after stitching. 9. Piece the quilt, as shown on the cutting and piecing page. 10. Sandwich batting between quilt and backing with wrong sides of finished quilt and backing against batting. 11. Quilt as desired. Patrick used a straight stitch, in matching thread, around each appliqué’s satin stitching and in the ditch of all seams. He stitched vertical lines on the bear background area and an echo stitch on “X” and “O” background area. 12. Bind as usual, using 2¼” strips cut from the binding fabric. Sew buttons to Teddy’s face for eyes and nose. Copyright 2015 ™
All Rights Reserved Visit www.patricklose.com
Cutting All seams are stitched at ¼". 1. From the blue fabric, cut one 9½ x 10½" piece for bear background and two 4½ x 4½" squares for the “O” appliqué background. 2. From the pink fabric, cut two 4½ x 4½" squares for “X” appliqué background/ 3. From the multi-blue fabric, cut three 1½ x 40" strips, from these strips cut two 1½ x 20½", two 1½ x 11½", two 1½ x 9½", and two 1½ x 4½" strips for border. 4. From the multi-stripe binding fabric, cut two 2¼ x 40" strips for binding. The remaining fabrics will be used for appliqués and backing.
Piecing
Make 2
Copyright 2015 ™
All Rights Reserved
bear
Trace and cut two “X” & “O” templates, and one of each remaining appliqué template.
Trace Line Placement Line Stitching Line Button Placement
All appliqués are printed in reverse for fusing onto the wrong sides of your appliqué fabrics. Dashed lines indicate placement or overlap of appliqués, or a stitching line.
Copyright 2015 ™
All Rights Reserved Visit www.patricklose.com
Trace Line Stitching Line Button Placement
inner ear inner ear muzzle
left foot pad
right foot pad
trace and cut two of each
heart
Copyright 2015 ™
All Rights Reserved Visit www.patricklose.com
No part of this pattern covered by the copyright hereon may be reproduced in any form by any means including, but not limited to, graphic, electronic, mechanical, photocopying, recording, taping, or information storage and retrieval systems without written permission from Patrick Lose. All finished items produced from this pattern and its instructions are protected by Federal Copyright Law and may not be produced for sale in any form whatsoever without the written consent of Patrick Lose.
