SDPK-9 LED 3 Light Puck Kit Installation Instructions - GM Lighting

SDPK-9 LED 3 Light Puck Kit Installation Instructions NOTE: Turn power off before wiring. Recessed - Cut a 2-1/4” hole in a desired location. Remove puck light from surface mounting ring (Fig. 1). . Push Puck Light up into hole where springs enable a snug fit (Fig. 2). Surface Mount - Install surface mounting ring with 2 screws (supplied) in the desired location making sure that wires are routed through notch cut in surface mounting ring. Push recessed puck light up into surface mounting ring, enabling springs to secure a snug fit (Fig. 2). Consult wiring diagram below, use with 12VDC Plug in or dimmable power supplies. 2-5/8” Dia.

120 volt input

L

LINE

N

NEUTRAL

¥

GROUND

Fig. 1 Surface mount ring

12VDC Power Supply V– 12vdc output

black wire

V– V+

red wire

V+

Fig. 2 Recessed puck light

+ red wire - black wire

Electrical Connection: 3 Puck Kit 1. 2. 3.

Locate position of pucks and install either surface or recess mount. Connect modular connectors to power supply and each puck. Plug in power supply into nearby power outlet.

For recessed installation cut hole 2-1/4” dia.

Three Puck Kit Schematic

24”

12”

12VDC

72”

Power Supply 12”

On / Off Switch

9830 W. 190th Street • Unit F • Mokena, IL 60448 Toll-Free (866) 671-0811 FAX: (708) 478-2640 www.gmlighting.net • Specifications subject to change without notice. SDPLED3Wpuckinst_032315