Brother PT-D200 Cutter Blade Replacement

Brother PT-D200 Cutter Blade Replacement

Brother PT-D200 Cutter Blade Replacement This guide will give you step-by-step instructions on how to replace the cutter blade on your Brother PT-D200.

Written By: Blaire McCreary

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 1 of 4

Brother PT-D200 Cutter Blade Replacement

INTRODUCTION This guide will walk you through the process of replacing a dull or broken cutter blade on a Brother PT-D200.

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 2 of 4

Brother PT-D200 Cutter Blade Replacement

Step 1 — Cutter Blade



Open the back panel of the device by pressing down on and then pulling the indication arrows on the top center of the cover upward towards you.

Step 2 

© iFixit — CC BY-NC-SA

www.iFixit.com

Locate the cutter blade unit (mint green) as shown in the picture.

Page 3 of 4

Brother PT-D200 Cutter Blade Replacement

Step 3



Using the thumb and forefinger, pull up, applying a moderate amount of pressure until the cutter blade unit loosens and is removed.

 The blade is sharp. To reassemble your device, follow these instructions in reverse order. This document was last generated on 2017-06-23 12:06:28 PM.

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 4 of 4