INTRODUCCIÓN As a computer is used, it generates heat. The cooling fan pulls air through the device to cool it down. If it becomes clogged with dust or breaks, the computer will overheat.
The hard drive assembly is attached to the laptop by a ribbon cable. Only lift the side of the drive facing you about an inch above the laptop. If you tear the ribbon cable the laptop will need to be serviced by a professional.
Use one finger to lift up the hard drive assembly from the bottom left corner.
Unplug the cable below the lower RAM slot by using the spudger to slide the two brown clips towards you.
Gently pull the cable towards you using the clear plastic tab.
Paso 16
Unclip the bottom half of the case from the laptop by using a spudger and starting at the USB port on the right side of the laptop. Then work your way clockwise around the laptop.
Lower the keyboard assembly towards the screen until the clips near the hinges detach.
Set the keyboard assembly aside.
Paso 20
Open the hinge to about 90 degrees.
Lift up the left edge of the tape holding the fan on the right side of the motherboard.
Push the fan out of the back of the laptop.
To reassemble your device, follow these instructions in reverse order. La versión más reciente de este documento fue generada en 2017-09-02 12:27:09 PM .