Bose SoundDock Portable v2 IR Receiver Replacement
Bose SoundDock Portable v2 IR Receiver Replacement
Bose SoundDock Portable v2 IR Receiver Replacement Written By: Evan Low
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 1 of 4
Bose SoundDock Portable v2 IR Receiver Replacement
INTRODUCTION This guide will help you replace the IR receiver in your Bose speaker.
TOOLS: T15 Torx Screwdriver (1) Metal Spudger (1) Tweezers (1)
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 2 of 4
Bose SoundDock Portable v2 IR Receiver Replacement
Step 1 — IR Receiver
Gently pry the front mesh cover off of the sound dock using a metal spudger.
The mesh is held on by small velcro strips so if you hear a tearing sound it is just the velcro coming apart.
Step 2
© iFixit — CC BY-NC-SA
www.iFixit.com
Using a T15 torx screwdriver, remove the 8mm screw holding the IR sensor to the speaker system.
Page 3 of 4
Bose SoundDock Portable v2 IR Receiver Replacement
Step 3
Using tweezers or your fingers, gently remove the ribbon cable connecting the IR sensor to the system.
To reassemble your device, follow these instructions in reverse order. This document was last generated on 2017-06-18 01:36:04 AM.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 4 of 4
Bose SoundDock Portable v2 IR Receiver Replacement Written By: Evan Low
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 1 of 4
Bose SoundDock Portable v2 IR Receiver Replacement
INTRODUCTION This guide will help you replace the IR receiver in your Bose speaker.
TOOLS: T15 Torx Screwdriver (1) Metal Spudger (1) Tweezers (1)
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 2 of 4
Bose SoundDock Portable v2 IR Receiver Replacement
Step 1 — IR Receiver
Gently pry the front mesh cover off of the sound dock using a metal spudger.
The mesh is held on by small velcro strips so if you hear a tearing sound it is just the velcro coming apart.
Step 2
© iFixit — CC BY-NC-SA
www.iFixit.com
Using a T15 torx screwdriver, remove the 8mm screw holding the IR sensor to the speaker system.
Page 3 of 4
Bose SoundDock Portable v2 IR Receiver Replacement
Step 3
Using tweezers or your fingers, gently remove the ribbon cable connecting the IR sensor to the system.
To reassemble your device, follow these instructions in reverse order. This document was last generated on 2017-06-18 01:36:04 AM.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 4 of 4
