India Mark II Riser Main Coupling Replacement

Report 5 Downloads 46 Views
India Mark II Riser Main Coupling Replacement

India Mark II Riser Main Coupling Replacement Prerequisite guide to install a coupling to the riser main before removing it from the well.

Written By: Andrew Optimus Goldberg

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 1 of 4

India Mark II Riser Main Coupling Replacement

INTRODUCTION Prereq only.

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 2 of 4

India Mark II Riser Main Coupling Replacement

Step 1 — Riser Main Coupling



Place a coupling over the pump rod, on top of the rod vise.

Step 2



Reattach the T-handle to the top of the pump rod.

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 3 of 4

India Mark II Riser Main Coupling Replacement

Step 3



Loosen and remove the rod vise from the pump rod.

 The coupling will drop down onto the riser main. Step 4



Screw the coupling onto the end of the riser main.



Use a pipe wrench to tighten the coupling onto the riser main.

To reassemble your device, follow these instructions in reverse order. This document was last generated on 2017-06-26 03:25:50 AM.

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 4 of 4