Microsoft Band Battery Replacement

Microsoft Band Battery Replacement

Microsoft Band Battery Replacement You will be replacing one or both batteries located in the side panels.

Written By: Monique Salinger

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 1 of 5

Microsoft Band Battery Replacement

INTRODUCTION There are two batteries in the band, located in the side panels. One battery compartment contains a vibrator, but the replacement steps are essentially the same. Warning: The following guide is likely to ruin the water resistance of the device.

TOOLS: Spudger (1) T3 Torx Screwdriver (1)

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 2 of 5

Microsoft Band Battery Replacement

Step 1 — Battery 

Unscrew both side panel 2mm screws using the T3 Torx screwdriver.



Firmly pry up the side panel using the plastic spudger to break the waterproof seal and lift the battery panel.

Step 2

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 3 of 5

Microsoft Band Battery Replacement

Step 3 

Gently pry up one edge of the battery with the plastic spudger.



Remove battery from its compartment with your fingers.

Step 4

To reassemble your device, follow these instructions in reverse order. Replace the vibrator in its original compartment. This document was last generated on 2017-06-18 07:09:51 PM.

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 4 of 5

Microsoft Band Battery Replacement

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 5 of 5