Off Switch Replacement
Conair Cord-Keeper 169XR On/Off Switch Replacement
Conair Cord-Keeper 169XR On/Off Switch Replacement This guide will show you how to disassemble the handle and replace the power button.
Written By: Candace
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 1 of 4
Conair Cord-Keeper 169XR On/Off Switch Replacement
INTRODUCTION If your dryer isn't turning on, the back of the On/Off button that engages the power may be broken.
TOOLS: Phillips #2 Screwdriver (1)
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 2 of 4
Conair Cord-Keeper 169XR On/Off Switch Replacement
Step 1 — Handle
Unscrew the two 18 mm long Phillips #2 screws on the side of the hair dryer.
Step 2
Some pieces may fall out when removing the face of the handle.
© iFixit — CC BY-NC-SA
www.iFixit.com
Once you have taken the screws out, take the top half of the handle off by lifting it off of the dryer.
Page 3 of 4
Conair Cord-Keeper 169XR On/Off Switch Replacement
Step 3 — On/Off Switch
Now take out the On/Off switch by gently pulling it out towards you and lightly pushing it to the right with your finger until it comes out of the groove it is resting in.
Once the new switch is in place you can put the dryer back together.
To reassemble your device, follow these instructions in reverse order. This document was last generated on 2017-06-27 12:36:46 AM.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 4 of 4
Conair Cord-Keeper 169XR On/Off Switch Replacement This guide will show you how to disassemble the handle and replace the power button.
Written By: Candace
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 1 of 4
Conair Cord-Keeper 169XR On/Off Switch Replacement
INTRODUCTION If your dryer isn't turning on, the back of the On/Off button that engages the power may be broken.
TOOLS: Phillips #2 Screwdriver (1)
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 2 of 4
Conair Cord-Keeper 169XR On/Off Switch Replacement
Step 1 — Handle
Unscrew the two 18 mm long Phillips #2 screws on the side of the hair dryer.
Step 2
Some pieces may fall out when removing the face of the handle.
© iFixit — CC BY-NC-SA
www.iFixit.com
Once you have taken the screws out, take the top half of the handle off by lifting it off of the dryer.
Page 3 of 4
Conair Cord-Keeper 169XR On/Off Switch Replacement
Step 3 — On/Off Switch
Now take out the On/Off switch by gently pulling it out towards you and lightly pushing it to the right with your finger until it comes out of the groove it is resting in.
Once the new switch is in place you can put the dryer back together.
To reassemble your device, follow these instructions in reverse order. This document was last generated on 2017-06-27 12:36:46 AM.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 4 of 4
