Plantronics CS50 Headset Motherboard of the Base Unit Replacement

Plantronics CS50 Headset Motherboard of the Base Unit Replacement

Plantronics CS50 Headset Motherboard of the Base Unit Replacement Replace the a dead base unit motherboard.

Written By: Bryan Clark

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 1 of 4

Plantronics CS50 Headset Motherboard of the Base Unit Replacement

INTRODUCTION Use this guide to replace your base unit's motherboard.

TOOLS: Phillips #0 Screwdriver (1)

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 2 of 4

Plantronics CS50 Headset Motherboard of the Base Unit Replacement

Step 1 — Motherboard of the Base Unit



Flip over the base unit to reveal the bottom.

Step 2



Using a #0 screwdriver, remove the two 2.50mm screws.

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 3 of 4

Plantronics CS50 Headset Motherboard of the Base Unit Replacement

Step 3



Separate, but do not remove, the silver upper piece from the dark lower piece.



Carefully disconnect the wires from the motherboard.



Remove the silver top of the base.

Step 4



Remove the motherboard from the base

To reassemble your device, follow these instructions in reverse order. This document was last generated on 2017-07-03 12:33:34 AM.

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 4 of 4