Quick Install Guide - Intellinet Network

Quick Install Guide

www.intellinet-network.com

Instructions

Repair a damaged plug quickly & easily Block is suitable for broken latch

Block is not suitable for cleaned latch

Placing a repair block over the lip and inserting into a jack will cause a jam.

Repair a damaged plug

RJ45 Repair Block

proper length

Assembly

Damaged plug

1. Use a cutting tool (or your fingers) to partially remove the existing latch on the cable's plug; leave a 1-mm lip. (Note: breaking the existing latch at too short or too long a length will make for a poor connection that could either jam or incorrectly fit your cable jack [see diagram below]). 2. If color-coding your cables, choose a repair block that matches the cable you want to repair. If not, select a block from the container. 3. Place the repair block over the base of the plug. If necessary, slide the top of the new clip under the 1-mm lip you cut. Installation is complete.

too short

too long

Finished

Other situations

(A)

(B)

(C)

Compliance Specification: °RoHS °REACH

Lifetime Warranty

If STP Plug bottom is too thick

INT-771436-771443-771450-QiG-0316-5.01