Removing the Covers of the Logitech Webcam Pro 9000
Removing the Covers of the Logitech Webcam Pro 9000
Removing the Covers of the Logitech Webcam Pro 9000 This will allow you to get to the main components of the device.
Written By: Timothy Forrest
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 1 of 4
Removing the Covers of the Logitech Webcam Pro 9000
INTRODUCTION Learn how to get to the interior of a Logitech Webcam Pro 9000. There are a few extra wires, so be careful not to pull the covers apart too quickly.
TOOLS: Phillips #0 Screwdriver (1)
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 2 of 4
Removing the Covers of the Logitech Webcam Pro 9000
Step 1 — Front and Back Cover
Remove the two 8mm Phillips#0 screws on the back cover.
The motherboard is attaching the two covers together, so don't separate them entirely just yet. There is a button that loosens as the Phillips screws are removed. Don't be alarmed if it falls out.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 3 of 4
Removing the Covers of the Logitech Webcam Pro 9000
Step 2
Remove the four 6mm Phillips#0 screws connecting the motherboard and front cover.
DO NOT detach the wire connecting the motherboard to the front cover. To reassemble your device, follow these instructions in reverse order. This document was last generated on 2017-07-02 12:15:36 PM.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 4 of 4
Removing the Covers of the Logitech Webcam Pro 9000 This will allow you to get to the main components of the device.
Written By: Timothy Forrest
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 1 of 4
Removing the Covers of the Logitech Webcam Pro 9000
INTRODUCTION Learn how to get to the interior of a Logitech Webcam Pro 9000. There are a few extra wires, so be careful not to pull the covers apart too quickly.
TOOLS: Phillips #0 Screwdriver (1)
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 2 of 4
Removing the Covers of the Logitech Webcam Pro 9000
Step 1 — Front and Back Cover
Remove the two 8mm Phillips#0 screws on the back cover.
The motherboard is attaching the two covers together, so don't separate them entirely just yet. There is a button that loosens as the Phillips screws are removed. Don't be alarmed if it falls out.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 3 of 4
Removing the Covers of the Logitech Webcam Pro 9000
Step 2
Remove the four 6mm Phillips#0 screws connecting the motherboard and front cover.
DO NOT detach the wire connecting the motherboard to the front cover. To reassemble your device, follow these instructions in reverse order. This document was last generated on 2017-07-02 12:15:36 PM.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 4 of 4
