Road Glide 15-UP

Road Glide 15-UP

Remove speaker covers first, then outer fair.

R for right L for left.

Remove speaker enclosures.

Use template for pilot hole.

Drill pilot hole.

Run in reverse 2 3/8” hole saw, same as 60mm. 1

Road Glide 15-UP

Glue port in place.

Remove grommet from wire to use later.

Remove small tab.

Use grommet in picture above with new wire

2

Road Glide 15-UP

Make sure of tweeter bridge alignment.

Blue ends to blue for woofer

Red ends to red for tweeter.

Pair left woofer and tweeter. Pair right

3

Road Glide 15-UP woofer and tweeter.

RCA in. on this amp look for square button.

Speaker level or high level in. Do not use both.

Power and ground to battery. Remove fuse until complete. Notice blue remote turn on. This is not necessary on all amplifiers.

If line level is used, pug in as shown.

4

Road Glide 15-UP Crossover on high pass, set around 100 hertz.

If you have a factory radio, turn speed volume off. If really attached to this feature, use no higher than level 1.

5