Safety DayLights™ Smart Controller

SAFETY DAYLIGHTS™ SMART CONTROLLER

Technology with Vision

Safety DayLights

NEW RELEASE

™

SMART CONTROLLER

This smart controller is designed to simplify the installation of HELLA’s LED Safety DayLights™ range by eliminating the need to wire the lamp, or changeover relay to ignition terminal 15. The Safety DayLights™ Smart Controller can be wired directly to the positive terminal of the battery, which saves the difficult and often time consuming task of finding the ignition feed. The smart controller monitors the voltage supply from the battery and will automatically switch the Safety DayLights™ on when the engine is started, and automatically switch them off when the headlamps are activated, or the engine is turned off. P/N 3090 Safety DayLights™ Smart Controller (Advanced*)

P/N 3091 Safety DayLights™ Smart Controller (Standard)

30

➔➔ One smart controller controls two lamps

Power Supply

➔➔ Quick and easy installation

30 9

59

78

50

DL1 86

11

Part Number

DL2

31

3090 (Advanced*) 3090 BULK (Advanced*)

Pack of 20

3091 (Standard)

30

3091 BULK (Standard)

All dimensions in mm RECOMMENDED INSTALLATION DIAGRAM FOR WIRING

Voltage

Multivolt , suitable for 12 and 24 volt systems.

Maximum Continuous Load

20W

To Suit

HELLA LED Safety DayLights™ range.

Pack of 20

™

Features a Safety DayLights™ OFF delay of approximately 10 seconds. *Advanced version with vibration monitor for installation in vehicles with fuel saving alternators. 31 3A Max.

DL1 86 30 DL2

Fuse

-

-

-

58

WIRING SPECIFICATIONS

Terminal Number

Connect to

30

Battery (+)

31

Earth return (-)

86

Front position or headlamps (+)

DL1 & DL2

Safety DayLights™ (+)

Marketed by: HELLA Australia Pty. Ltd. • Techline 1800 061 729 • Fax +61 (0)3 9585 2654 • [email protected] • www.hella.com.au