Skil 88 Trigger Mechanism Replacement

Skil 88 Trigger Mechanism Replacement

Skil 88 Trigger Mechanism Replacement Removing and replacing the trigger mechanism of the Skil 88 drill.

Written By: Matt

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 1 of 4

Skil 88 Trigger Mechanism Replacement

INTRODUCTION After opening the trigger housing, one of the things you can do is replace and remove the trigger mechanism. It's as simple as getting the housing open.

TOOLS: .25" Socket Wrench (1)

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 2 of 4

Skil 88 Trigger Mechanism Replacement

Step 1 — Trigger Housing



Use the socket wrench to remove the 0.5" length screw from the bottom of the handle.

Step 2



Separate the cord from the handle.

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 3 of 4

Skil 88 Trigger Mechanism Replacement

Step 3 — Trigger Mechanism

 Make sure that the drill is completely unplugged. 

Locate the two wires attached to the black trigger.



Pull the wires out of the trigger. It may take a bit of force.



Push the wires into the new trigger piece.



Make sure the wires go back into the correct holes.

Step 4

To reassemble your device, follow these instructions in reverse order. This document was last generated on 2017-06-25 11:23:30 AM.

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 4 of 4