Sony Clie PEG-UX50 Rear Case Replacement

Sony Clie PEG-UX50 Rear Case Replacement

Sony Clie PEG-UX50 Rear Case Replacement This instructs user how to remove the rear cover of a Sony Clie PEG-UX50

Written By: Christopher M Garcia

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 1 of 5

Sony Clie PEG-UX50 Rear Case Replacement

INTRODUCTION Rear Cover Removal allows the inside of the Clie to be exposed for further replacement of internal components

TOOLS: Phillips #1 Screwdriver (1) Tweezers (1)

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 2 of 5

Sony Clie PEG-UX50 Rear Case Replacement

Step 1 — Rear Case 

Tools needed:



Tweezers



Philips Screwdriver

Step 2



Using Phillips screwdriver, remove 4 screws from the rear cover.



Remove 1 screw from the right side.



Remove 1 screw from the top

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 3 of 5

Sony Clie PEG-UX50 Rear Case Replacement

Step 3



Gently pry rear cover to remove USB port cover and Hold Switch.

Step 4



Remove side cover.



Gently pull the rear cover to separate from device.

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 4 of 5

Sony Clie PEG-UX50 Rear Case Replacement

Step 5 

Slowly pull rear cover from device being careful not to pull the speaker connection wire.



Remove speaker wire from device.



The rear cover is now separated from the device.

To reassemble your device, follow these instructions in reverse order. This document was last generated on 2017-06-24 06:15:01 PM.

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 5 of 5