Sprout channel cubby camera Replacement
Sprout channel cubby camera Replacement
Sprout channel cubby camera Replacement removal and replacement of the devices camera
Written By: jasen biggins
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 1 of 4
Sprout channel cubby camera Replacement
INTRODUCTION This guide will require the use of a phlipes head screwdriver. The ribbon connector is usually the reason the device will need this replacement.
TOOLS: iFixit Opening Tools (1) 64 Bit Driver Kit (1)
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 2 of 4
Sprout channel cubby camera Replacement
Step 1 — Front Half
Begin by prying apart your device and pushing in tabs. It is easiest to start on the corners.
There are 16 tabs in total.
Step 2 — camera
© iFixit — CC BY-NC-SA
www.iFixit.com
The first step to removing the camera is to unscrew it from the device (there is only one screw).
Page 3 of 4
Sprout channel cubby camera Replacement
Step 3
First pull back on the tab.
Once this is done remove the film from the device connected to the camera, once this is done it is able to be taken right out.
Follow the steps in reverse order to install the new camera
To reassemble your device, follow these instructions in reverse order. This document was last generated on 2017-07-13 07:45:10 AM.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 4 of 4
Sprout channel cubby camera Replacement removal and replacement of the devices camera
Written By: jasen biggins
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 1 of 4
Sprout channel cubby camera Replacement
INTRODUCTION This guide will require the use of a phlipes head screwdriver. The ribbon connector is usually the reason the device will need this replacement.
TOOLS: iFixit Opening Tools (1) 64 Bit Driver Kit (1)
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 2 of 4
Sprout channel cubby camera Replacement
Step 1 — Front Half
Begin by prying apart your device and pushing in tabs. It is easiest to start on the corners.
There are 16 tabs in total.
Step 2 — camera
© iFixit — CC BY-NC-SA
www.iFixit.com
The first step to removing the camera is to unscrew it from the device (there is only one screw).
Page 3 of 4
Sprout channel cubby camera Replacement
Step 3
First pull back on the tab.
Once this is done remove the film from the device connected to the camera, once this is done it is able to be taken right out.
Follow the steps in reverse order to install the new camera
To reassemble your device, follow these instructions in reverse order. This document was last generated on 2017-07-13 07:45:10 AM.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 4 of 4
