Dymo LabelManager 280 Screen Replacement - The-Eye.eu!

Dymo LabelManager 280 Screen Replacement

Dymo LabelManager 280 Screen Replacement Replace the screen in order for it to work again.

Written By: Steven Nguyen

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 1 of 6

Dymo LabelManager 280 Screen Replacement

INTRODUCTION This guide helps open the device and get to the screen to replace it.

TOOLS: Phillips #0 Screwdriver (1) Spudger (1)

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 2 of 6

Dymo LabelManager 280 Screen Replacement

Step 1 — Rear Case



Remove battery.



Remove the label cassette.

Step 2



Remove the 6 screws in the indicated places. These particular screws are 2mm x 8mm Phillips #0 head

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 3 of 6

Dymo LabelManager 280 Screen Replacement

Step 3



Use the spudger to take apart the device by insterting it as shown in the picture and twisting it. This should be done all around the device to ensure the two parts split correctly.

 The keys/buttons highlighted in the second picture fall out easily so be careful. Keep device faced down in order to keep them from falling.

Step 4 — Screen



© iFixit — CC BY-NC-SA

www.iFixit.com

Further remove the 2 screws (1.2mm X 4mm Phillips #0 head).

Page 4 of 6

Dymo LabelManager 280 Screen Replacement

Step 5



Detach the ribbon cable.

Step 6 

Remove the screen.

To reassemble your device, follow these instructions in reverse order. This document was last generated on 2017-06-19 12:57:40 PM.

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 5 of 6

Dymo LabelManager 280 Screen Replacement

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 6 of 6