PLTW Technical Support Document
Installation Guide for Autodesk Inventor Professional 2015 (Network Installation) Updated: 05/1/15
Before you begin, you will need to: 1. Downloaded Inventor Professional 2015 from the ARC Portal. 2. Access your Product Key and Serial Number from the ARC portal. a. If you don’t have this information go to http://www.autodesk.com/pltw-signin and request your Serial Number and Product Key.
Procedure 1. Run the Installer you downloaded from the ARC portal. 2. After the files extract the installer will automatically launch. Select Install.
3.
Select I Accept and Next.
4.
Input your Serial Number and Product Key from the ARC Portal and put in the Host Name of your Server and select Next.
Page 2 of 3
5.
Keep the selection of “Autodesk Inventor Professional 2015” and select Next.
6. Select the down arrow under Autodesk 2015.
7. Scroll down to the section titled “Service Packs” and select Download to include the most current Service Pack with your install.
8.
Once the service pack has fully downloaded select the up arrow to close the configure dropdown.
If further technical support is needed Email: [email protected]
Page 3 of 3
9.
Uncheck “Autodesk Vault Basic 2015 (Client)”, “Autodesk ReCap”, and “Autodesk 360”. These are not needed for PLTW Curriculum and can save space by not being installed.
10. Select Install and the installation process will begin and select Finish when complete.
If further technical support is needed Email: [email protected]
Before you begin, you will need to: 1. Downloaded Inventor Professional 2015 from the ARC Portal. 2. Access your Product Key and Serial Number from the ARC portal. a. If you don’t have this information go to http://www.autodesk.com/pltw-signin and request your Serial Number and Product Key.
Procedure 1. Run the Installer you downloaded from the ARC portal. 2. After the files extract the installer will automatically launch. Select Install.
3.
Select I Accept and Next.
4.
Input your Serial Number and Product Key from the ARC Portal and put in the Host Name of your Server and select Next.
Page 2 of 3
5.
Keep the selection of “Autodesk Inventor Professional 2015” and select Next.
6. Select the down arrow under Autodesk 2015.
7. Scroll down to the section titled “Service Packs” and select Download to include the most current Service Pack with your install.
8.
Once the service pack has fully downloaded select the up arrow to close the configure dropdown.
If further technical support is needed Email: [email protected]
Page 3 of 3
9.
Uncheck “Autodesk Vault Basic 2015 (Client)”, “Autodesk ReCap”, and “Autodesk 360”. These are not needed for PLTW Curriculum and can save space by not being installed.
10. Select Install and the installation process will begin and select Finish when complete.
If further technical support is needed Email: [email protected]
