Porter-Cable PC60TAG Power Cord Replacement

Porter-Cable PC60TAG Power Cord Replacement

Porter-Cable PC60TAG Power Cord Replacement Replace the power cord on your Porter-Cable PC60TAG.

Written By: Mackenzie Fairbanks

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 1 of 5

Porter-Cable PC60TAG Power Cord Replacement

INTRODUCTION Often times power cords can get damaged through long-term use, or mishandling of the device. Whatever the case, the power cord of the Porter-Cable PC60TAG can be replaced in a few easy steps.

TOOLS: Phillips #2 Screwdriver (1)

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 2 of 5

Porter-Cable PC60TAG Power Cord Replacement

Step 1 — Power Cord 

Using the Phillips #2 screwdriver, remove the 3/4" Phillips head screw on the back cover.

 Unplug the grinder before disassembling.

Step 2 

© iFixit — CC BY-NC-SA

www.iFixit.com

Holding the front of the device, carefully slide the back cover over the cord.

Page 3 of 5

Porter-Cable PC60TAG Power Cord Replacement

Step 3 

Using the Phillips #2 screwdriver, remove the two 1/2" Phillips head screws securing the cord grip.



Using the Phillips #2 screwdriver, loosen, but do not remove, the two terminal screws securing the black and white wires from the power cord.

Step 4

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 4 of 5

Porter-Cable PC60TAG Power Cord Replacement

Step 5 

Careful remove each wire from the power cord from underneath the terminals.

To reassemble your device, follow these instructions in reverse order. This document was last generated on 2017-06-26 02:55:37 AM.

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 5 of 5