Procedure to install printer drivers and print from Windows
Procedure to install printer drivers and print from Windows
Step 1
-
Go to Start > Run Command > Type \\192.168.40.8 > Press Enter. See Below
-
You will get an Authentication screen. Username is same as your Hult Id (Ex- Jsmith2013) and Password is the first 5 digits on the back of your printer/access card.
-
You will get a folder with printer drivers. Right click on Student Papercut Printer and select Connect
-
The new printer you installed is now visible in Devices and Printers.
-
Now that you have set up the new printer, you have to install Paper cut client. Go to Start > Run Command > Type \\192.168.40.8 > Press Enter > Go to PCClient > Win.
Step 2
-
Click on Client-local-install
-
The client installation will start as shown below.
-
Click on Run and it will start Paper Cut Client Setup wizard.
-
On the Select Component page, select Local Install (My account only). See below.
-
Then Click on Finish to complete the installation.
-
Once installation is complete, it will open a screen as shown below. This shows the initial balance in your wallet.
Step 3
Now you can print any documents and you have access to both the printers as shown below.
When you try to print out a document, you will get a password prompt. Use your Paper cut Username and password. Username is same as your Hult Id (Ex- Jsmith2013) and Password is the first 5 digits on the back of your printer/access card.
After you have clicked Ok, a message is displayed saying that your document was sent to the printer.
Step 4
To collect your print, flash your Access card on the scanner attached to the printer. This will automatically log you in the printer and show you the jobs waiting in your queue. In the picture below the document’s name is Untitled Notepad.
Select the document you want to print and then click on Print.
In case you have no document waiting in the queue, you will see the below message.
Step 1
-
Go to Start > Run Command > Type \\192.168.40.8 > Press Enter. See Below
-
You will get an Authentication screen. Username is same as your Hult Id (Ex- Jsmith2013) and Password is the first 5 digits on the back of your printer/access card.
-
You will get a folder with printer drivers. Right click on Student Papercut Printer and select Connect
-
The new printer you installed is now visible in Devices and Printers.
-
Now that you have set up the new printer, you have to install Paper cut client. Go to Start > Run Command > Type \\192.168.40.8 > Press Enter > Go to PCClient > Win.
Step 2
-
Click on Client-local-install
-
The client installation will start as shown below.
-
Click on Run and it will start Paper Cut Client Setup wizard.
-
On the Select Component page, select Local Install (My account only). See below.
-
Then Click on Finish to complete the installation.
-
Once installation is complete, it will open a screen as shown below. This shows the initial balance in your wallet.
Step 3
Now you can print any documents and you have access to both the printers as shown below.
When you try to print out a document, you will get a password prompt. Use your Paper cut Username and password. Username is same as your Hult Id (Ex- Jsmith2013) and Password is the first 5 digits on the back of your printer/access card.
After you have clicked Ok, a message is displayed saying that your document was sent to the printer.
Step 4
To collect your print, flash your Access card on the scanner attached to the printer. This will automatically log you in the printer and show you the jobs waiting in your queue. In the picture below the document’s name is Untitled Notepad.
Select the document you want to print and then click on Print.
In case you have no document waiting in the queue, you will see the below message.
