TomTom One XL Battery Replacement

Report 12 Downloads 124 Views
TomTom One XL Battery Replacement

TomTom One XL Battery Replacement Replace the battery of the TOMTOM XL if the battery is dead or malfunctioning.

Written By: DeVhan

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 1 of 6

TomTom One XL Battery Replacement

INTRODUCTION This guide will teach you how to replace the battery of the TOMTOM XL if the battery is dead or malfunctioning.

TOOLS: 1.41in x 12yd double sided tape (1) iFixit Tech Knife (1)

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 2 of 6

TomTom One XL Battery Replacement

Step 1 — Back Panel



Remove the 4 .4mm screws on the back of the device.

Step 2 

Using the palate knife tool, pry the back from the LCD screen. Apply a moderate pressure to separate them.

 You can rotate TOMTOM XL to make prying back off easier.

 Be careful not to injure the two wires connecting the pieces.

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 3 of 6

TomTom One XL Battery Replacement

Step 3 

After prying both halves apart, they will be connected by two wires.



Carefully set the two halves next to each other making sure not to stress or damage the wires.

Step 4



Using the tweezers separate the wires connecting the battery and speaker to the mother board.

 Be gentle while pulling the wires out, the plugs are easily injured.

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 4 of 6

TomTom One XL Battery Replacement

Step 5 — Battery 

Using metal palate knife pry the battery from the back panel.

Step 6



Place the backside of the battery on the sticky side of the double sided tape.



Using the tech knife, trim the extra tape to the size of the battery.

 The tech knife is sharp, be careful when cutting the tape.

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 5 of 6

TomTom One XL Battery Replacement

Step 7



Remove the back of the double sided tap.



Place the new battery back inside the back panel of TOMTOM XL.

 Make sure the wire from the battery is going in the correct direction. Step 8



Reconnect the battery ribbon cable to its port.

To reassemble your device, follow these instructions in reverse order. This document was last generated on 2017-07-15 02:59:33 PM.

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 6 of 6