Beats Mixr Headband Replacement
Beats Mixr Headband Replacement
Beats Mixr Headband Replacement In this guide I will be giving you step by step instructions on how to replace the headband on you Beats Mixr Headphones.
Written By: Allie Horton
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 1 of 3
Beats Mixr Headband Replacement
INTRODUCTION Beats mixr have a very flexible headband that is made to bend in different ways. After time, the headband can weaken and break. Luckily, it is an easy fix.
TOOLS:
PARTS:
Spudger (1)
Beats Headphone Band (1)
Phillips #00 Screwdriver (1)
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 2 of 3
Beats Mixr Headband Replacement
Step 1 — Remove the caps on the headband
Use a spudger or prying tool to remove the cap on both sides of the headband by applying pressure where the cap meets the band. Next, you will need a Phillips head #00 screwdriver to remove the screws and washer. Twist the screwdriver into the screw and pull it apart from the washer when it becomes loose.
Begin by pulling the two parts of the headband away from each other slowly and make sure not to break any wires. The wires will now slide free of the headband.
Step 2 — Separate the ear cuff from the headband.
To reassemble your device, follow these instructions in reverse order. This document was last generated on 2017-06-17 12:03:53 PM.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 3 of 3
Beats Mixr Headband Replacement In this guide I will be giving you step by step instructions on how to replace the headband on you Beats Mixr Headphones.
Written By: Allie Horton
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 1 of 3
Beats Mixr Headband Replacement
INTRODUCTION Beats mixr have a very flexible headband that is made to bend in different ways. After time, the headband can weaken and break. Luckily, it is an easy fix.
TOOLS:
PARTS:
Spudger (1)
Beats Headphone Band (1)
Phillips #00 Screwdriver (1)
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 2 of 3
Beats Mixr Headband Replacement
Step 1 — Remove the caps on the headband
Use a spudger or prying tool to remove the cap on both sides of the headband by applying pressure where the cap meets the band. Next, you will need a Phillips head #00 screwdriver to remove the screws and washer. Twist the screwdriver into the screw and pull it apart from the washer when it becomes loose.
Begin by pulling the two parts of the headband away from each other slowly and make sure not to break any wires. The wires will now slide free of the headband.
Step 2 — Separate the ear cuff from the headband.
To reassemble your device, follow these instructions in reverse order. This document was last generated on 2017-06-17 12:03:53 PM.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 3 of 3
