Black and Decker JS660 Angle Lock Replacement
Black and Decker JS660 Angle Lock Replacement
Black and Decker JS660 Angle Lock Replacement The lever used to lock the jigsaw at a certain cutting angle is not locking.
Written By: Andrew Khouri
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 1 of 5
Black and Decker JS660 Angle Lock Replacement
INTRODUCTION This guide will give instructions on how to change out the lever that locks the jigsaw to the cutting angle desired.
TOOLS:
PARTS:
Screwdriver (1)
Handle to change the cutting angle (1)
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 2 of 5
Black and Decker JS660 Angle Lock Replacement
Step 1 — Base
Unscrew the nine screws to open up the jigsaw
Step 2
© iFixit — CC BY-NC-SA
www.iFixit.com
Unscrew the base by unscrewing the two shown in the picture.
Page 3 of 5
Black and Decker JS660 Angle Lock Replacement
Step 3
The Jigsaw base will now be off. With the new base simply do the reverse order of steps.
Assemble the base on a steady surface. Step 4 — Angle Lock
Remove the screw marked and the lever will slide out easily
The black screw must next be removed.
After removing the screw the lever will slide out of the jigsaw.
To reassemble your device, follow these instructions in reverse order. © iFixit — CC BY-NC-SA
www.iFixit.com
Page 4 of 5
Black and Decker JS660 Angle Lock Replacement This document was last generated on 2017-09-23 02:28:07 AM.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 5 of 5
Black and Decker JS660 Angle Lock Replacement The lever used to lock the jigsaw at a certain cutting angle is not locking.
Written By: Andrew Khouri
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 1 of 5
Black and Decker JS660 Angle Lock Replacement
INTRODUCTION This guide will give instructions on how to change out the lever that locks the jigsaw to the cutting angle desired.
TOOLS:
PARTS:
Screwdriver (1)
Handle to change the cutting angle (1)
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 2 of 5
Black and Decker JS660 Angle Lock Replacement
Step 1 — Base
Unscrew the nine screws to open up the jigsaw
Step 2
© iFixit — CC BY-NC-SA
www.iFixit.com
Unscrew the base by unscrewing the two shown in the picture.
Page 3 of 5
Black and Decker JS660 Angle Lock Replacement
Step 3
The Jigsaw base will now be off. With the new base simply do the reverse order of steps.
Assemble the base on a steady surface. Step 4 — Angle Lock
Remove the screw marked and the lever will slide out easily
The black screw must next be removed.
After removing the screw the lever will slide out of the jigsaw.
To reassemble your device, follow these instructions in reverse order. © iFixit — CC BY-NC-SA
www.iFixit.com
Page 4 of 5
Black and Decker JS660 Angle Lock Replacement This document was last generated on 2017-09-23 02:28:07 AM.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 5 of 5
