Koosh Vortex Tornado Barrel Shield Spring Replacement

Koosh Vortex Tornado Barrel Shield Spring Replacement

Koosh Vortex Tornado Barrel Shield Spring Replacement Replace the barrel shield spring on your Koosh Vortex Tornado.

Written By: Jordon Roseman

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 1 of 4

Koosh Vortex Tornado Barrel Shield Spring Replacement

INTRODUCTION This guide will show you how to replace the barrel shield spring on the Koosh Vortex Tornado.

TOOLS: Phillips #1 Screwdriver (1) Spudger (1) Plastic Metal Spudger is preferred

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 2 of 4

Koosh Vortex Tornado Barrel Shield Spring Replacement

Step 1 — Barrel Shield Spring 

Remove the fourteen 150 mm Phillips #1 screws on the side of the body.



Pull the shells apart to show the inside of the gun. Set the left shell aside.

Step 2

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 3 of 4

Koosh Vortex Tornado Barrel Shield Spring Replacement

Step 3 

Using a spudger, unhook the barrel shield's spring from the base of the gun.

To reassemble your device, follow these instructions in reverse order. This document was last generated on 2017-06-18 08:35:54 AM.

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 4 of 4