Procedure to install printer drivers and print from Windows
Procedure to install printer drivers and print from Windows Step 1: Go to Start > Run Command > Type \\192.168.40.8 > Press Enter. See Below
You will get an Authentication screen. Key in your id which is same as your OneLogin id and password is the first 5 digit on the backside of your printer card
You will get a folder with printer drivers. Right click on printers and select Connect. There are two printers for students. You can connect to both AED-HLT-WIFI-PRN1 and AED-HLT-WIFI-PRN2
After you install the printer drivers, you can see the printers in Devices and Printers.
Step 2: After setting up printers, you now have to install Paper cut client. Go to Start > Run Command > Type \\192.168.40.8 > Press Enter > Go to PCClient > Win. See below.
Click on Client-local-install
The client installation will start as shown below.
Click on Run and it will start Paper Cut Client Setup wizard.
On the select component screen, select Local Install (My account only). See below.
Then Click on finish to complete the installation. See below.
Once installation is complete, it will open a screen as shown below. This shows balance in your wallet.
Step 3: Now, you can print any document. You can see both the printers as shown below.
Once you click on print, you will get a password prompt. Use your Paper cut Username and password. Username is same as your Hult Id (Ex- Jsmith2013) and Password is the first 5 digits on the back of your printer/access card.
After you click Ok, a message is displayed saying that your document was sent to the printer. Step 4: To collect your print out, flash your Access card on the scanner attached to the printer. This will automatically log you in the printer and show you the jobs waiting in your queue. In the picture below the document name is Untitled Notepad.
Select the document you want to print and then click on Print.
You see the below message if you have no document waiting in the queue.
You will get an Authentication screen. Key in your id which is same as your OneLogin id and password is the first 5 digit on the backside of your printer card
You will get a folder with printer drivers. Right click on printers and select Connect. There are two printers for students. You can connect to both AED-HLT-WIFI-PRN1 and AED-HLT-WIFI-PRN2
After you install the printer drivers, you can see the printers in Devices and Printers.
Step 2: After setting up printers, you now have to install Paper cut client. Go to Start > Run Command > Type \\192.168.40.8 > Press Enter > Go to PCClient > Win. See below.
Click on Client-local-install
The client installation will start as shown below.
Click on Run and it will start Paper Cut Client Setup wizard.
On the select component screen, select Local Install (My account only). See below.
Then Click on finish to complete the installation. See below.
Once installation is complete, it will open a screen as shown below. This shows balance in your wallet.
Step 3: Now, you can print any document. You can see both the printers as shown below.
Once you click on print, you will get a password prompt. Use your Paper cut Username and password. Username is same as your Hult Id (Ex- Jsmith2013) and Password is the first 5 digits on the back of your printer/access card.
After you click Ok, a message is displayed saying that your document was sent to the printer. Step 4: To collect your print out, flash your Access card on the scanner attached to the printer. This will automatically log you in the printer and show you the jobs waiting in your queue. In the picture below the document name is Untitled Notepad.
Select the document you want to print and then click on Print.
You see the below message if you have no document waiting in the queue.
