DYMO LabelPOINT 100 Cutting Blade Replacement - The-Eye.eu!

DYMO LabelPOINT 100 Cutting Blade Replacement

DYMO LabelPOINT 100 Cutting Blade Replacement Replace a dull, broken, or jammed cutting blade.

Written By: Dustin Holifer

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 1 of 4

DYMO LabelPOINT 100 Cutting Blade Replacement

TOOLS: Phillips #00 Screwdriver (1)

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 2 of 4

DYMO LabelPOINT 100 Cutting Blade Replacement

Step 1 — Rear Panel



Slide the panel release button.



Lift the panel.

Step 2 — Remove Label Tape Cassette



Firmly press the cartridge release button with your finger. 



You may need to hold the cassette and/or entire device still while pressing the button.

Lift the label tape cassette out of the device.

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 3 of 4

DYMO LabelPOINT 100 Cutting Blade Replacement

Step 3 — Blade Disassembly



Use Phillips #00 Screwdriver to disengage cutter from device



Remove cutter

Step 4 — Remove Blade



Use Phillips #00 screw to unscrew blade from blade cutter

 Carefully remove blade. The blade is sharp and can be dangerous if not handled properly. 

Replace blade

To reassemble your device, follow these instructions in reverse order. This document was last generated on 2017-06-21 06:52:51 PM.

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 4 of 4